User manual MAKITA UR3000

[. . . ] The stand should be bolted in a stable and level surface using the bolts provided on two of four feet. Use only the handle to avoid pinched fingers when raising or folding the stand. [. . . ] When storing table saw stand, never lean it against the wall or the like lengthwise or sideways. Move the leg in the direction of arrow and then remove the table-raising/lowering bolt with a spring from the nut holder. Remove a bolt and a washer from the top of the table-raising/lowering bolt with the hex wrench. Note: At this time, beware that a bearing unit will not come off from the bolt top. If it comes off by mistake and comes apart, reassemble it with each groove in two plates of the bearing unit facing the bearing balls and return it to the original position on the bolt. 11, 12) Secure them to fix the axis with the bolts, washers and nuts that have been just removed by tightening firmly with two wrenches. Also, secure them to lock the tire wheel plate with the just removed bolt and washers. When securing table saw on the table saw stand, holes on your tool base match holes in the stand. When setting up the table saw stand in the upright position, turn the handle clockwise. Adjust the levelness of the table saw stand by rotating the foot, and then secure the table saw stand by turning the nut. [. . . ] Adjust the levelness of the table saw stand by rotating the foot, and then secure the table saw stand by turning the nut. Secure the foot of stand to the stable and level surface using holes in the fix plates with two hex bolts. [. . . ]