User manual MAKITA UR360D

[. . . ] Speed change switch lever Indicator lamps Most effective cutting area CHECK button Spacer Nylon cutting head Bolts Protector cover Lock key Cutter holder 21. Cover Latches Press Spool For right hand rotation Notches Eyelets Protrusion (Not shown) Slot of the eyelet SPECIFICATIONS Model No load speed Overall length Cutting diameter with nylon cutting head Net weight Rated voltage Standard battery cartridge(s) Warning: Use only the battery cartridge(s) described. 36 V BL3622A/BL3626 • Due to our continuing program of research and development, the specifications herein are subject to change without notice. € Specifications and battery cartridge may differ from country to country. [. . . ] To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. CAUTION: • Always install the battery cartridge fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. If the cartridge does not slide in easily, it is not being inserted correctly. Reversing is used only when weeds and debris are entangled in the tool. To operate the tool normally the “A” side of the switch should be depressed. If weeds and debris are jammed in the rotating head, the tool can be reversed by depressing the “B” side of the switch. WARNING: • Always be sure that the tool is switched off and battery cartridge is removed before removing weeds or debris entangled in the tool that is not removed by the reverse mode. Failure to switch off and remove the battery cartridge may result in serious personal injury from accidental start-up. NOTICE: • Always check the direction of rotation before operation. € Use the reversing switch only after the tool comes to a complete stop. Do not change the direction of rotation while the head is still rotating, the tool may be damaged. Power switch action WARNING: • Before inserting the battery cartridge in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. Do not pull the switch trigger hard without pressing in the lock-off button. Operating a tool with a switch that does not actuate properly can lead to loss of control and serious personal injury. 6) To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. To start the tool, press in the lock-off button and pull the switch trigger. The tool speed is increased by increasing pressure on the switch trigger. € Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. ASSEMBLY WARNING: • Always be sure that the tool is switched off and battery cartridge is removed before carrying out any work on the tool. Failure to switch off and remove the battery cartridge may result in serious personal injury from accidental start-up. Operation of the tool in a partially assembled state may result in serious personal injury from accidental start-up. [. . . ] Cut the grass using the nylon cord tip by moving the trimmer from right to left and proceed slowly, keeping the trimmer at the angle of about 30° in relation to the ground surface. When cutting high grass, cut in layers always beginning from the top with each cut length short. TROUBLE SHOOTING Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do not attempt to dismantle the tool. [. . . ]