User manual MAKITA UT120

[. . . ] Disconnect from mains supply whenever any work, servicing and adjustment or change of accessories and cutters is required. [. . . ] Prior to work starting, make sure that cutting accessory is fitted properly. To avoid machine self-starting, always trigger-off the switch should power supply become interrupted or plug accidentally withdrawn from the socket while motor is still running. When machine is used outdoors, only use extension cords intended and approved for such application by complying with your local regulations. Always have mains cable routed to the rear and away from the machine and moving parts. Keep sure-footing and body balance at all times for better control of reaction torque. Hence, the following instruction should be observed: Use only Makita paddles with M14 internal thread. The operating voltage must correspond with that indicated on identification plate. Short-Time Operation switching-on: press the on/off switch switching-off: release the on/off switch Permanent Operation Switching-on: press the on/off switch and keeping it pressed, engage the lock button Switching-off: press the on/off switch and let it go off again The UT120 is equipped with an electronic, realizes the following functions: - Infinitely variable speed adjustment with the controller speed Position Position I IIIIIII slow fast - load independent speed stabilisation Take always care for cleanliness of the thread and the rim. [. . . ] We declare under our sole responsibility that this product is in compliance with the following standards or standardized documents, EN50144, HD400 in accordance with Council Directives, 89/336/EEC and 98/37/EC [. . . ]