User manual MAKITA UT121

[. . . ] Generally accepted accident prevention regulations and the safety instructions enclosed shall be observed. Power supply The machine shall only be connected to the voltage stated on the type plate and it only works with single-phase AC voltage. It is provided with double protective insulation according to European standards and thus, it may be also connected to sockets without ground cable. [. . . ] During assembly and disassembly work, voltage drop, insertion and/or assembly of accessories. Do switch off the tool if it stops to operate due to whatever cause in order to avoid a sudden start of operation when it is unattended. do not use the tool if a part of the housing and/or the switch , cable or plug is damaged. Do ensure that the handle bars are dry, clean and free from oil and grease. When the tool is operated manually, make sure that you always hold the tool with both hands and you stand in a firm position. Therefore, the following instructions shall always be observed: Use stirrers recommended by the manufacturer (maximum diameter: 120 mm with M14 thread). Do always remove the power plug before carrying out any work on the tool. Do use a SW 22 spanner to remove the stirrer and to hold up the work spindle. Switching the machine on and off Short-Time Operation Starting the machine: Stopping the machine: Permanent Operation Starting the machine: Stopping the machine: Press on/off switch Release on/off switch Press on/off switch and while keeping it pressed, engage the lock button Press on/off switch again and release it Do only use the lock button if the tool is operated with the supporting stand. If a standstill caused by the tool or a power failure occurs, do immediately loosen the lock button by pressing the on/off switch in order to avoid the unintended restart of the tool (risk of injury). The mixer has an electronic switch in order to regulate the speed level by keystrokes. It is recommended to only use it when the machine is started or stopped in order to avoid splashing material. If the continuous mode is operated with reduced speed, it leads to overstress because the machine is not provided with enough cooling air and overheating will occur significantly faster. Care and Maintenance Repairs shall only be carried out by qualified staff trained and experienced in this area. The tool shall be inspected by a skilled electrician after every repair. The power tool is designed to require only a minimum of maintenance and care. [. . . ] In order to be accurate, an estimation of the level of exposure to vibration should also take into account the times when the tool is switched off and when it is running but not actually used. This may significantly reduce the level of exposure to vibration during the whole working period. Additional protective measures in order to protect the operator from vibration effects, e. [. . . ]