User manual MAKITA VC3210L

[. . . ] A power source with voltage greater than that specified for the cleaner can result in SERIOUS INJURY to the operator as well as damage to the cleaner. Using a power source with voltage less than the nameplate rating is harmful to the motor. Do not attempt to pick up flammable materials, fire works, lighted cigarettes, hot ashes, hot metal chips, sharp materials such as razors, needles, broken glass or the like. Never vacuum up toxic, carcinogenic, combustible or other hazardous materials such as asbestos, arsenic, barium, beryllium, lead, pesticides, or other health endangering materials. [. . . ] Make sure that both the cleaner and the electric power tool are switched off before connecting or disconnecting. Connecting the power tool to the cleaner with both of them being switched on may cause unexpected and sudden start resulting serious personal injury. When connecting a grounded tool, insert a plug with a grounding plate to the socket of the cleaner. Never connect an electric power tool with an input power exceeding that specified in the "SPECIFICATIONS" to the socket of the cleaner by turning the suction force adjusting knob. Connecting the electric power tool exceeding the specified input power may cause overheat and damage to the cleaner. The cleaner can be connected to an electric power tool up to input power shown in the "SPECIFICATIONS". To connect an electric power tool, open the cap and insert the power tool plug into the socket of the cleaner. 2) Move the suction force adjusting knob to the position suitable for the input power of the electric power tool you intend to use. Refer to the SPECIFICATIONS for the relation between suction force adjusting knob and the electric power tool input power. Switching on and off of the connected electric power tool simultaneously brings the cleaner switching on and off action. The cleaner still works for a few seconds even after the electric power tool is switched off. Do not use the cleaner or a connected electric power tool with a power supply cord wound on the base hook. Using the cleaner or the connected electric power tool with power supply cord may cause damage the power supply cord. Storing the front cuffs Front cuffs 22, 24 and 38 can be stored (up to two at a time. Resting a reasonable size of electric power tool for the base hook, such as circular saw. 10) To lock the caster with a stopper, lower the stopper lever and the caster no longer will rotate. To release the caster from the locked position, raise the stopper lever. Locking the caster is convenient when storing the cleaner, stopping the work on the way and keeping the cleaner still. Moving the cleaner with the caster in the locked position may cause damage to the caster. The pipe holder that is excessively lowered than the intended position cannot be installed on the cord hook with the hook away from the tank cover as shown in the figure. Make sure that the two hooks of the pipe holder are hooked on the tank cover securely. Always be sure that the cleaner is switched off and unplugged before carrying out any work on the cleaner. [. . . ] 36) The pipes can be placed into the pipe holder when also stopping using the cleaner on the way for a while. Do not apply an excessive force to the accessories that are held by the pipe holder. Applying an excessive force to these accessories may cause damage to the pipe holder. 33) Pipe holder can be used to store straight pipe, bent pipe, corner nozzle and similars by just inserting these accessories. [. . . ]