User manual MANFROTTO 521P

[. . . ] Switch the camera ­ now you may start using the controller Remote Zoom Controller is designed to work only with PANASONIC AG-DVX100 and AG-DVC80 video cameras, which have the 2. Switch the camera ­ now you may start using the controller >>> 8 After switching the camera on, the LANC controller LED indicator should light continuously. The last used zoom speed mode will be set ­ the current setup will be indicated by one of zoom speed LEDs. LED indicator not lighting at all means problem with power supply of the controller. [. . . ] rotate the knob left (or right , dependent on the zoom direction) to zoom wide. OPERATION ­ model 521PRO NOTE: Not all function may be available depending on camera working mode e. If using Sony camera Memory mode the "Record start/stop" functions are not working. The zoom mode LED should light below or above the button indicating zoom speed limit mode. Selecting zoom mode To choose between zoom modes, press the zoom speed button. When you press the button for the first time, the "P" LED below the button will go on, indicating that you work in progressive mode with zoom speed limit. Pressing the button for the second time will make the "F" LED above the button to go on and the "P" LED to go off, indicating that you work in fixed zoom speed mode with zoom speed limit. Pressing the button for the third time, will make the LEDs to go off, indicating that you work in default mode ­ progressive zoom speed mode with no zoom speed limit. if the LED "P" is on , maximum zoom speed is limited to the pre-set zoom speed. rotate the knob right (or left , dependent on the zoom direction) to zoom tele. Zoom speed is always constant, limited to the pre-set speed indicated by LED. rotate the knob left (or right , dependent on the zoom direction) to zoom wide. Zoom speed is always constant, limited to the pre-set speed indicated by LED. Customizing zoom speed limit Rotate the zoom wheel and zoom with any speed you prefer. The new speed limit will be saved in microcontroller internal flash memory and restored after each power off. Custom speed reprogramming may be done practically unlimited number of times (min. Resetting zoom speed limit The zoom speed button is factory pre-set to the slowest speed possible with LANC protocol. To reset the zoom speed button to factory pre-sets stop zooming (release the zoom knob) and press the button. The new zoom direction information will be permanently stored in the controller's internal flash memory and restored after each power off. Standby mode Press the button once to switch camera into standby mode. [. . . ] High temperature Avoid temperatures exceeding +70°C ­ especially do not leave the controller exposed for direct contact with heavy sun shines, e. Electrical precaution The cable is always one of the most easy breakable element of any electronic system, especially when as exposed to mechanical wear off. Therefore to extend the life of your controller and make the basic "repair" as cheap as possible we decided to allow easy cable exchange. However, to avoid accidental short circuiting the camera connection, you must remember to always plug the cable to the controller first. [. . . ]