User manual MAXDATA INSTRACK2

[. . . ] Installation Guide for the Rack-Mount Slide Rail Kit from MAXDATA PLATINUM 200 and 500 Parts List The following is a list of all the parts that are relevant for installation; each part is designated with a letter that is used in the installation guide. External rail: A Middle rail: B Internal rail: C The middle rail (B) is slid inside the external rail (A) and the internal rail (C) in turn is inside the middle rail (B). End bracket: D Round head screw, large: E Round head screw, small: F Nut: G Perforated plate with threaded holes: H Note: Countersunk screws are not required. [. . . ] Measure the distance between the front and rear breadboard section of your cabinet. Attach the silver end brackets (D) to the external rail (A) with two screws (E) and two nuts (G) each. Be careful to make sure that the distance between the fastening bracket for the external rail (A) and the end bracket (D) is the same as the distance between both breadboard sections of your server cabinet. H Front: A Rear: D E 4. Attach the rails in the rear of the server cabinet with the silver end brackets (D). Then set the perforated plate with the threaded holes (H) behind the breadboard section. Finish by inserting the screws (E) from the front through the breadboard and the fastening bracket to the perforated plates (H). F 5. [. . . ] To be able to slide the server completely inside, you have to push in the locking device at both sides of the rails. [. . . ]