User manual MAXDATA MPL 520 ANHANG RACKINSTALLATION

[. . . ] MAXDATA PLATINUM 520/220 Installation Guide for the Rack-Mount Slide Rail Kit Parts List The following is a list of all the parts that are relevant for installation; each part is designated with a letter that is used in the installation guide. External Rail The middle rail (B) is slid inside the external rail (A) and the internal rail (C) in turn is inside the middle rail (B). Middle Rail Internal Rail End Bracket Round head screw, large Round head screw, small Nut Perforated Plate with threaded holes NOTE Countersunk screws are not required. Tip: Customers with a MAXDATA rack can simplify installation of the server by taking the screws, washers, and clamping nuts from the fastening set of their cabinet. MAXDATA PLATINUM 520/220 1 Installation 1. [. . . ] Be careful to make sure that the distance between the fastening bracket for the external rail (A) and the end bracket (D) is the same as the distance between both bread-board sections of your server cabinet. 2 Installation Guide for the Rack-Mount Slide Rail Kit 4. Attach the rails in the rear of the server cabinet with the silver end brackets (D). Then set the perforated plate with the threa-ded holes (H) behind the breadboard section. Finish by inserting the screws (E) from the front through the breadboard and the fastening bracket to the perforated plates (H) Front: A Rear: D 5. Attach the internal rails (C) with the locking device in the rear of the server housing with the small screws (F). 6. When finished, you can slide the server into the server cabinet by pushing the inner rail (C) into the middle rail (B). [. . . ] To be able to slide the server completely inside, you have to push in the locking device at both sides of the rails. MAXDATA PLATINUM 520/220 3 [. . . ]