User manual MEDION BDAPC8810PT

[. . . ] Faults · Remove the mains adapter(s) from the power socket immediately if the mains adapter, the connection cable or the devices are damaged. · If the appliance is not going to be used for long periods, remove the plug from the mains socket. Health Issues The low transmitting power of the devices eliminates any danger to health according to the current state of research and technology. Cleaning and care · Use a soft, dry cloth to clean the devices. [. . . ] Scart or Cinch If the audio/video source has a SCART connection, use the SCART adapter for the transmitter. If the device connected to the receiver has a SCART connection use the SCART adapter for the receiver. If the device connected to the receiver does not have a SCART connection, use the DIN-AV cinch cable or a 75 Ohm aerial cable. If the audio/video source has a 3. 5mm audio output use the audio adapter supplied. 9 81241 TEVION UK. book Seite 10 Mittwoch, 23. August 2006 1:47 13 Range Audio and video signals are transmitted in the 2. 4GHz range. August 2006 1:47 13 SCOPE OF DELIVERY Remove all packing materials. When unpacking, ensure that the following parts are included: · Transmitter · 1x mains adapter for the transmitter 6 V 300 mA · Receiver · 1x mains adapter for the receiver 6 V 300 mA Cables supplied · 1 infrared extender with three external IR transmitters · 1x SCART adapter for the transmitter · 1x SCART adapter for the receiver · 1x DIN SCART cable for the A/V input "source device 1" · 1x DIN SCART cable for the A/V output "TV" 11 81241 TEVION UK. book Seite 12 Mittwoch, 23. August 2006 1:47 13 · 1x audio adapter 3. 5mm stereo jack to cinch socket · 1x AV cinch cable · 1x DIN AV cinch cable Packaging The radio transmission system is packaged to protect it against transportation damage. Packaging is raw material and can be re-used or added to the recycling system. 12 81241 TEVION UK. book Seite 13 Mittwoch, 23. August 2006 1:47 13 CONNECTING Setting up THE TRANSMITTER · Place the transmitter on a sturdy surface. · Align the flat side of the transmitter aerial with the receiver. · The operating system and the drivers for your graphics card support video output. How to proceed Output via video output is activated differently depending on your operating system and graphics card. As there are numerous combinations of these, we can only provide general instructions here. Please check the operating instructions for your computer or graphics card to see how you can divert the image to video output. The following example requires a PC running the Windows® 98 operating system or above. · Refer to the operating instructions for your PC and follow the instructions for using video output. · Connect the yellow plug on the AV cinch cable to the 19 81241 TEVION UK. book Seite 20 Mittwoch, 23. If your graphics card does not have a cinch output, use a suitable adapter (optional accessory). · Connect the red and white plugs on the AV cinch cable to your PC's audio output. PCs usually have 3. 5mm stereo jacks, so you can use the adapter supplied. · Now connect the free end of the AV cinch cable to the corresponding coloured connectors on the transmitting station. · Open up the transmitter aerial and align it with the transmitter until you have the optimal image. [. . . ] In this case, switch to a different channel for transmitting the signal. 26 81241 TEVION UK. book Seite 27 Mittwoch, 23. August 2006 1:47 13 TROUBLESHOOTING If errors occur, check first that the system was set up correctly. The following overview may help you: No audio/video transmission · Are all mains adapters plugged in?· Are the channels for the transmitter and the receiver the same? [. . . ]