User manual MEDION CD MP3 RDS CAR RADIO MD 41804

[. . . ] 5 2-speaker system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Installation instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Push the car radio carefully into the slot until it fits securely. Installation frame Screwdriver While pushing the radio, take care to ensure that the cables are not damaged during the process. Press the RESET BUTTON (15) using the tip of a pen or another sharp object. Insert the control panel as described in the next section. Please use the car radio's ISO block for installation. These adapters can be obtained from specialist workshops, dealers, or specialist departments of car equipment warehouses. If the ISO block is separated from the radio the warranty will become NULL AND VOID! INSERT THE CONTROL PANEL Push the car radio forward into the slot until it fits securely. Press von below and close the control panel, so that you can see the display. Control panel 7 Autoradio_41804_UK. FH11 Thu Oct 14 15:46:44 2004 Seite 9 REMOVING THE CONTROL PANEL Press the OPEN button (2). The control panel separates itself from the housing and you can remove it. For protection, always keep the control panel in its case. Open PROBLEMS DUE TO INCORRECT CABLE CONNECTIONS In some vehicle models, the standard arrangement of the cables [4] and [7] in the ISO block A (see below, "ARRANGEMENT OF THE ISO BLOCK") is exchanged at the factory. If this is the case in your vehicle, certain functions may be impaired: stations may not be stored properly, for example. To solve this, the red cable switched plus and the yellow cable (permanent plus) will need to be reversed in the ISO block. ARRANGEMENT OF THE ISO BLOCK 2468 BLOCK B Speakers BLOCK A Electricity supply 1357 1 back right + 1 A 2 back right 2 2468 3 front right + 3 4 front right 4 Switched plus (permanent 12 V supply from main electrical system) 5 front left + 5 Auto. antenna (also for external amplifiers, etc. ) 6 front left 6 7 back right + 7 Alternating plus (alternating 12 V voltage, via ignition) 8 back right 8 Earth/ground B 1357 8 Autoradio_41804_UK. FH11 Thu Oct 14 15:46:44 2004 Seite 10 O P E R AT I O N BASIC OPERATION SWITCHING ON/OFF Press the POWER button (9) to switch the car radio on or off. VOLUME/BASS/TREBLE/BALANCE/FADER By pressing the SEL button (1) repeatedly you can display the volume, bass, treble, balance and fader settings and adjust them using the VOL+/VOL- (1) multi-keys control. MENU FUNCTIONS Hold down the SEL (1) key for longer than 1 second to call up the menu. The individual menus are: MASK DPI/MASK ALL, DSP OFF/POP M/ROCK M/CLASS M/FLAT M, LOUD ON/LOUD OFF, BEEP ON/BEEP OFF, SEEK 1/SEEK 2, STEREO/MONO, LOCAL/DX, VOL LAST/ VOL ADJ. MODE - Radio/CD mode Press the MODE (13) key to switch between the RADIO and CD modes 9 Autoradio_41804_UK. FH11 Thu Oct 14 15:46:44 2004 Seite 11 RADIO FUNCTIONS SELECT BAND Press the BND button (6) to switch between FM (FM1, FM2, FM3) and medium wave (MW1, MW2). You can search forwards or backwards by holding down one of these buttons. STORING STATIONS After the tuning function has located a station, keep one of the number buttons 1-6 (12) held down for a few seconds. FINDING STORED STATIONS By pressing a number button 1-6 (12) you can locate the stations you have stored. STORING STATIONS AUTOMATICALLY (AP) By pressing the AP button (5) all stations that can be picked up will be stored in order. [. . . ] This is more user-friendly than with an audio CD, where only the title (track) numbers are displayed. When producing your MP3 CDs, please take care to ensure that you can input or modify the ID3 tag for your MP3 CDs yourself using an ID3 tag editor available from specialist providers. 14 Autoradio_41804_UK. FH11 Thu Oct 14 15:46:44 2004 Seite 16 TROUBLESHOOTING PROBLEM The unit cannot be switched on. Remove the CD from the unit. The CD cannot be loaded or No sound! Function buttons do not work! The CD jumps Radio and/or the automatic station memory do not work. Station storage function does not work. The volume is set to minimum. [. . . ]