User manual MEDION TELEPHONE WITH ANSWERING MACHINE MD 40920

[. . . ] Insert the batteries into the compartment, observing the polarity (+/­): Reversed batteries may cause damage to the device. Battery precautions Follow these precautions when using batteries in this device: 1. If the device is not to be used for a long period of time, remove the battery to prevent damage or injury from possible battery leakage. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. Installing the answering machine Connect the small plug of the AC adaptor with the 9 V jack on the back of the unit. [. . . ] Make sure the VOLUME control is at a desirable level. 8 Tel+AM_MD40920_UK. fm Seite 9 Mittwoch, 7. April 2004 9:52 09 OPERATION OF ANSWERING MACHINE To record a new outgoing message, please repeat these steps. Recording OGM2 To record this message, proceed as described in the passage , , Recording OGM1", however, use the OGM2 button. (Make sure to add in you OGM that the caller cannot leave a message. ) The maximum recording time of an incoming message is 90 seconds. Two-Way Recording With the two-way recording, you can tape a current conversation. During telephone talking, press and hold two-way button for 2 seconds until a long beep is heard. Verifying the OGM Press and release the OGM1 or OGM2 button and the selected OGM will play. Press the STOP/TIMER button to stop playback before the end of the outgoing message is reached. NOTE: If the unit detects a dial tone, silence or a busy signal, the unit will hang up and not register the message. When the batteries are low, flat or not installed, "Lo" will blink in the display. MD 40920 9 Tel+AM_MD40920_UK. fm Seite 10 Mittwoch, 7. April 2004 9:52 09 OPERATION OF ANSWERING MACHINE Setting the unit to answering mode ANSWER/RECORD MODE Answer/Record mode In the Answer/Record mode, the unit will play the OGM1 and then record a message. Press the ON/OFF button once; the unit will emit 2 short beeps and then play OGM1. The message counter will then appear in the display indicating the unit is in Answer/Record mode. Speak mode In normal mode, neither the OGM nor the incoming message will be heard. If you wish to hear the incoming message, press the button SPEAK after the answer machine has started. Answer-only mode In the Answer-Only mode, the unit will play the OGM2 and then disconnect. Press the ON/OFF button once (OGM1 will play and 2 short beeps will be heard). Press the ON/OFF button again and the unit will emit 3 short beeps and then play OGM2. Answer-off mode Press the ON/OFF button unitl "--" appears in the display to set the unit to the Answer-off mode. Setting the number of rings The amount of times the phone rings before picking up the incoming message can be set to 2, 3, 4 or Toll-Saver. The toll saver will answer the call on the fourth ring if no messages have been recorded and it will answer on the second ring if new messages have been recorded; this feature is useful when phoning in for your messages. Press and hold the RING button for 2 seconds; the unit will beep and the present ring setting will blink: 2: Unit set to answer after 2 rings 3: Unit set to answer after 3 rings 10 Tel+AM_MD40920_UK. fm Seite 11 Mittwoch, 7. [. . . ] To stop monitoring, press "9". Selecting the answer mode Call the answering machine from a separate line. Press the "8" pad to cycle through the modes (Answer/Record, Answer-Only and Answer-off). After pressing the "8" pad, you will hear the respective OGM. If you only hear a long beep, then the unit is set to the Answer-Off mode. [. . . ]