User manual MEDION TFT DISPLAY MD 30048

[. . . ] Read these instructions carefully under all circumstance and follow all the instructions listed. You will guarantee the reliable operation and a long life expectancy of your LCD TV in this way. In the event that you transfer ownership of this LCD TV, please provide these instructions to the new owner. This means that it can transmit high resolution television programmes (HDTV) in principle. [. . . ] INFO: In the television mode: For displaying information, such as the current channel number and picture format. Number keys Television mode: channel selection; Teletext mode: Entry of the three-digit numbers, with which the page is selected. Note Read the Safety Information Chapter from Page 1 ff under all circumstances before bringing the device into operation. Please keep the packaging material well and use it exclusively to transport the television. Install two AAA size, type R03 batteries according to the correct polarity (marked in the battery compartment). Remove the batteries from the remote, if the device will not be used for a longer period. Connect the aerial socket and the television device to the RF IN connection with a doubly screened aerial cable (not in the scope of the delivery) for the connection to the external aerial or the cable plant. Plug the power supply cable into the power supply socket of the device. Connect the mains connection cable supplied with the device to a well accessible 230 V ~ 50 Hz mains socket. Put the main switch on the lower section of the television in the `I' (ON) setting. The device will go into Standby Mode and the display on the front will shine red. You will switch the device back to the Standby Mode with the STANDBY button. Put the main switch on the lower section of the television in the `0' (OFF) setting, in order to switch the device off completely. Select the options from the sub-menu with the / / directional buttons. Confirm the option selected from the Main Menu and open the sub-menu with the Confirm the option selected from the sub-menu in which you want to make changes or settings with the tional buttons. Set the required vale or make a different selection with the / directional buttons. You will close the Menu and confirm the selection at the same time with the EXIT button [7]. The Menu will close automatically if you do not press a button for longer than 15 seconds when operating the OSD. Select the SYSTEM Menu point (4th Menu point in the Main Menu strip on the left of the picture [MAIN MENU] with the directional button. Select the TV-CHANNEL Menu point (5th Menu point in the Main Menu strip on the left of the picture [MAIN MENU] with the directional button. Note You will be able to change the sequence of the channel positions according to your requirements. Read how you can sort the channels under the PROGRAM INSERT Menu point in the in the `TV-CHANNEL Menu' section from Page 20. [. . . ] Place the unit as far apart as possible from device that may cause possible interference. You have forgotten the password If the suggestions in the above section have not solved your problem, please contact the hotline. However, before you contact your Service Center, please keep the following information available: · If you have already been given a customer number, please keep this available. Before cleaning, always remove the power adapter plug and all connecting cables. [. . . ]