User manual MEDION TFT DISPLAY MD 32117

[. . . ] 17 Inch TFT Color Monitor Operating Instructions © 2006 All rights reserved. Trademarks: MS-DOS® and Windows® are registered trademarks of Microsoft®. Medion® makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Medion® shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. [. . . ] / Canadian purposes: The PC should only be connected to equipment which complies with UL 60950 / CAN CSA 22. 2 No 60950 Important Additional Safety Instructions When using any electronic equipment, basic safety precautions should always be taken. Following the guidelines below can reduce the risk of fire, electric shock and injury to person: · Do not use this product near water (e. g. , near a bathtub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool). · Avoid using a telephone/modem (other than a cordless type) during an electrical storm. · Do not use the telephone/modem to report a gas leak in the vicinity of the leak. · Keep batteries away from children at all times. 4 ENGLISH FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Shielded interface cables, if any, must be used in order to comply with the emission limits. Declaration of Conformity According to 47CFR, Parts 2 and 15 for Class B Personal Computers: We: Medion Aktiengesellschaft____________ (Name of the Responsible Party) Located at: Gänsemarkt 16 ­ 18_________________ D-45127 Essen_____________________ Germany__________________________ (Address, City, State, Zip Code) Fax : 0 201 / 81 081 ­ 227____ (Facsimile Number for conformity issues only) Declare under sole responsibility that the product identified herein, complies with 47CFR Parts 2 and 15 of the FCC rules as a Class B digital device. Each product marketed, is identical to the representative unit tested and found to be compliant with the standards. Records maintained continue to reflect the equipment being produced can be expected to be within the variation accepted, due to quantity production and testing on a statistical basis as required by 47CFR §2. 909. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. The above named party is responsible for ensuring that the equipment complies with the standards of 47CFR §§15. 101 to 15. 109. Trade Name: Type or Model Number: Party Responsible: Executed on (Date), at (Place): Medion MD 32117 PQ MEDION AG 14th of September, 2006, Essen SAFETY AND PRECAUTIONS 5 Start-Up Note Before start-up always read the Chapter "Safety and Precautions" on page 1ff. Mounting the Monitor Stand Mount the monitor stand as shown in the diagram. Perform this step before connecting the monitor. Ill. : Mounting the monitor stand Preparations on Your Computer If you have operated your computer previously with a CRT monitor, it will be necessary for you to make a few preparations. This is required when your previous monitor was operated with settings which are not supported by your new TFT monitor. Supported Monitor Settings This TFT monitor supports the following modes: Resolution 720 x 400 640 x 480 640 x 480 640 x 480 800 x 600 800 x 600 800 x 600 1024 x 768 1024 x 768 1024 x 768 Horizontal Frequency 31. 47 KHz 31. 47 KHz 37. 86 KHz 37. 5 KHz 37. 88 KHz 48. 08 KHz 46. 87 KHz 48. 36 KHz 56. 48 KHz 60. 02 KHz Vertical Frequency 70 Hz 60 Hz 72. 8 Hz 75 Hz 60. 3 Hz 72. 2 Hz 75 Hz 60 Hz 70. 1 Hz 75 Hz 60. 02 Hz 75 Hz *recommended physical resolution 1280 x 1024* 63. 98 KHz 1280 x 1024 80. 00 KHz Display Properties This Windows program offers you the possibility of adapting the display to your monitor. This includes items such as the background image, the screen saver, the Active Desktop (Web) as well as other settings for your monitor and video card. The program can be started as follows: 6 ENGLISH · Right mouse click on Windows desk top and left mouse click on "Properties". Or · Start the "Display" program in "System control". (Ill. : Display Properties) The resolution can be set under "Screen resolution". [. . . ] Economic follow-on damage (including lost profit or savings) or associated damage even in the case that we have been informed of the possibilities of this type of damage. In some countries the exclusion or limitation of accompanying or follow-on damage is not legally accepted so that the above limitations do not come into force. Copying this manual This document contains legally protected information. Copying in mechanical, electronic and any other form without the written approval of the manufacturer is prohibited. 18 ENGLISH Pixel Defects on TFTs (LCD-Displays) Active matrix TFTs (LCD) with a resolution of 1280 x 1024 pixel (SXGA), which are in turn composed of three sub-pixels each (red, green, blue), contain about 3. 9 million addressable transistors. Because of this very high number of transistors and their extremely complex production process occasionally defective or incorrectly addressed pixels or sub-pixels may occur. [. . . ]