User manual MEDION TITANIUM MD 8386 PC

[. . . ] NOTES ON THIS MANUAL Keep these instructions with your computer at all times. The proper set up, use and care can help extend the life of your computer. In the event that you transfer ownership of this computer, please provide these instructions to the new owner. This manual is divided into sections to help you locate the information you require. [. . . ] This cable is not included with your computer but may be obtained from an audio/video specialist or dealer. Read the operating instructions for your television set to find out which cable you need. THE GRAPHICS CARD 49 Appendix Help Operation Video Ausgang S-Video Connecting Safety HOW TO CONNECT THE PC TO A TELEVISION: To use the TV function you must first connect the TV to the graphics card before starting up the PC. Connect an S-Video, a SCART or a Composite cable to on the respective connector of your PC (reference V/V2/V3) and on you TV set. The Video Output connectors at the back of you PC are only for playback. For video recording please use the Video Input (composite or S-Video) connectors at the front of your PC. 50 OPERATION THE SOUND CARD Your PC has an integrated stereo sound card. The sound card is compatible with the industry standard Sound Blaster and Microsoft Sound System Version 2. 0. NOTE: The speaker/headphones output is designed for active speaker systems or headphones. Passive speakers cannot be used or if they are the quality will be significantly reduced. If your PC is equipped with a surround sound you can set it with the enclosed software as required. For this purpose click on the symbol USB PORT Devices connected directly to the USB bus should not draw more than 500 mA. The voltage output is protected by a fuse (Limited Power Source according to EN 60950). Should the devices need more power than this, it will be necessary to provide a hub (distributor / booster). On the USB it is possible to connect up to 127 devices which correspond to the USB standard (1. 1 and 2. 0 supported). The data transfer speed is 1. 5 Mbit or 12 Mbit, depending on the device connected. NOTE: If possible, connect your USB devices always to the same port were it has been installed. Otherwise you will get a new ID and your operating system asks for a new installation of the driver. THE SOUND CARD 51 Appendix Help Operation Connecting Safety IEEE 1394 (FIRE WIRE) The IEEE 1394 connector, also known as iLink® or Fire Wire, is a serial bus standard used for rapid digital data exchange. APPLICATION OPTIONS FOR IEEE1394 Connection of digital devices of the entertainment industry, such as set-top speakers, digital video and camcorder, `Digital Versatile Disk' (DVD), television etc. Input and output devices such as printers, scanners, etc. TECHNICAL SPECIFICATIONS Depending on the application, the maximum data transfer is about 100, 200 or 400 Mbit/s, corresponding to a data throughput of up to 50 MB per second. The device can be plugged in or unplugged during operation (hot plugging). The standardised cord (`Shielded Twisted Pair' -STP) includes 6 strands. Two lines are live (8V up to 40V, 1. 5 A max. ) and can be used as an external power supply. Some devices do not require a power supply via the cord so that four pole plugs are used. The voltage output of the 6-pole IEEE 1394 jack is protected by a fuse (limited power source according to EN60950). NOTE: The IEEE 1394 ports located at the front of you PC can only be used separately. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · · · Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. [. . . ]