User manual MEDION UNIVERSAL REMOTE CONTROL MD 41666

[. . . ] The batteries must be disposed of at a collection point for used batteries. 4 PROGRAMMING THE DEVICE CODES The codes of the respective devices can be found in the code list attached to these operating instructions. 3 seconds until the backlight illumination of the MODE keys flashes shortly and then lights up steadily. 1 (By briefly pressing the "SETUP" key, you activate the SHIFT function. ) 3. Briefly press the desired mode key (TV, VCR, DVD, SAT, DSAT, CD, CBL, AUX)2. [. . . ] You will find the brands in the code table under "Code search by brands". 3 seconds until the backlight illumination of the MODE keys flashes shortly and then lights up steadily. (By briefly pressing the "SETUP" key, you activated the SHIFT function) 3. Briefly press the desired MODE key (TV, VCR, DVD, SAT, DSAT, CD, CBL, AUX). Enter the applicable one-digit code from the table below: key 1 = Medion, Tchibo key 2 = Philips, Radiola, Philco, Erres, Pye key 3 = Sony, Akai, Panasonic, JVC, Sharp, Toshiba, Daewo key 4 = Thomson, Brandt, Fergusson key 5 = Saba, Nordmende, Telefunken key 6 = Grundig, Blaupunkt key 0 = all brands. Press the CHAN+ key (or, in case of video cassette recorders, POWER or PLAY) until the device responds correctly. Proceed swiftly when doing this, otherwise the automatic code search will be started. If all codes have been searched, the MODE key will blink for about 3 seconds. 8 Code identification The code identification allows you to identify codes that you have already entered and that are memorised in the remote control. 3 seconds until the backlight illumination of the MODE keys flashes shortly and then lights up steadily. (By briefly pressing the "SETUP" key, you activated the SHIFT function) 2. Each time you press a key, the MODE key illumination will briefly go out. Each time you press a key, the MODE key illumination will briefly go out. When the MODE key illumination goes briefly out, this is the memorised numeral. The MODE key will go out as soon as the key for the third number has been pressed. The code identification has now been completed. 9 LEARN FUNCTION The universal remote control provides you with the possibility of manually storing certain special functions which have not been stored, or even devices which have not been included in the code list. To do this, the original remote control of your device is required in any case. However, please note the following tips beforehand in order to avoid any mistakes. · Place the remote controls with the infrared diodes on a table so that they point each other at a distance between 15 and 50 mm. · You can store up to 150 commands. When the memory is full, the backlight illumination of the MODE key will be flashing for 3 seconds. · If you want to programme an additional function to an existing code, verify in advance which key has not yet been allocated and is still free for programming. · The following keys cannot be programmed with functions: LEARN, SETUP, ALL OFF, MACRO, SHOWVIEW and all MODE keys. · First have a try by programming any desired code and testing it then. [. . . ] 3 seconds until the backlight illumination of the MODE keys flashes shortly and then lights up steadily. (By briefly pressing the "SETUP" key, you activated the SHIFT function) 3. SHIFT function Some keys of the universal remote control can be allocated twice. To use these functions, briefly press the "SETUP" key (MODE key lights up) and subsequently one of the function or numerical keys. [. . . ]