User manual MEDION UNIVERSAL REMOTE CONTROL MD 80383 CODELIST

[. . . ] Enter the e-digit code from the code table; the MODE key will flash shortly for confirmation each time you press a key. If the code entered is the right one, the MODE key will go out when the last digit has been entered. If an invalid code is entered, the MODE key will flash for three seconds before going out. ­ The direct transfer of the code for your device has now been completed. [. . . ] Switch on the device (TV, VCR, etc. ) manually which you want to operate. 3 seconds until the backlight illumination of the MODE keys flashes shortly and then lights up steadily. (By briefly pressing the "SETUP" key, you activated the SHIFT function) 3. Point the remote control at the device and press the CHAN+ key once briefly. If the device does not possess a channel function, then press the PLAY or POWER key instead of CHAN+. After 6 seconds, the remote control will start the code search and successively send all codes at one second intervals (also see the next section). As soon as the device does respond to the remote control, press the OK key. ­ Should you fail to press the OK key in time, you can step by step return to the code to which the device has responded using the CHAN- key. 1-second or 3-second intervals If you want the remote control only to send a new code every 3 seconds instead of every second, proceed as follows: After you have pressed the CHAN+ (or PLAY or POWER) key as described in section 5, press the CHAN+ key (search forwards) or CHAN(search backwards) another time within 6 seconds. Now, the remote control will send new codes only at intervals of 3 seconds. This will give you more time, but the procedure will also take longer. 7 Code search by brand This function provides you with the possibility of searching by brands. Do not use the learn function beneath an energy saving lamp. 10 Programming functions Programming is carried out as follows: 1. 3 seconds until the backlight illumination of the MODE keys flashes shortly and then lights up steadily. (By briefly pressing the "SETUP" key, you activated the SHIFT function) 2. Briefly press the desired MODE key (TV, VCR, DVD, SAT, DSAT, CD, CBL, AUX). Now press the key on the universal remote control with which the respective function is to be programmed (the MODE key will permanently light up). Hold the key of your original remote control now down until the MODE key of the universal remote control will go out once (each false programming will be indicated by blinking of the key). Deleting functions To delete all codes referring to a device selection key, proceed as follows: 1. 3 seconds until the backlight illumination of the MODE keys flashes shortly and then lights up steadily. (By briefly pressing the "SETUP" key, you activated the SHIFT function) 2. All codes referring to the respective device selection key which had been programmed by the LEARN function have now been deleted. 11 To delete all codes proceed as follows: 1. 3 seconds until the backlight illumination of the MODE keys flashes shortly and then lights up steadily. [. . . ] Example: · while the remote control is in VCR, DVD, SAT or CBL mode, the VOLUME and MUTE keys control the TV set; 15 · while the remote control is in TV mode, the keys PLAY, STOP, PAUSE, FAST FWD/BWD, SKIP and, if applicable, RECORD will control a connected player or recorder. Switching off the universal functions VOLUME/MUTE You can perform the functions VOLUME and MUTE from any mode. even the volume control of satellite receivers or cable set top boxes when in TV mode. You can switch these universal functions off altogether (to avoid that you e. g. [. . . ]