User manual MEDION UNIVERSAL REMOTE CONTROL MD 80896 CODELIST

[. . . ] Along with the Table of Contents at the beginning of this manual, an Index has been provided to help you find topical information. If you want to start up your PC immediately, please read the chapters Operational Safety (page 3) and Setting up and Getting Started (page 8). We strongly recommend you read this entire manual to ensure the proper set-up and operation of your PC. As a general rule, you can access help functions by pressing F1 on the keyboard. [. . . ] D:\Driver This folder includes the drivers required by your computer (pre-installed). D:\Tools Here you find additional programs and other documentation for your PC. D:\Recover Here the backup files are located enabling you to recover the factory setting (see page 62). OPERATION 35 Appendix Help Operation Connecting Safety The Optical Drive Diagram reference: A Loading a Disc: Attention!To avoid damage to your drive, do not use deformed of damaged CD's. Attention: Do not use scratched or dirty disks, discs with pieces broken off or disks of poor quality. Because of the high speeds in the drive the disks might break and damage your data as well as your drive. Damage caused by faulty media is excluded from warranty and their repair must be charged. Push the eject button (Diagram reference, B) on the right of the optical drive to open the tray. Place the disc on the tray so that it lays flat with the label facing upward. This depends on the operating system and the corresponding settings. 36 THE OPTICAL DRIVE Playing Back and Retrieving Data from Discs Your PC is able to playback and to retrieve Audio CDs, DVD Movies and Data discs. After loading the disc your operating system will open a selection window with different options for playback. Note You will need a SCART, S-video, composite or a component cable for connecting your device to the PC according to the equipment. This is not included in the scope of the delivery, but it can be obtained through a specialist shop. Read precisely which cable you need in the Operating Instruction of your TV device. How to Connect the PC to a Television: Note To use the TV function you must first connect the TV to the graphics card before starting up the PC. Connect the composite or S-video input on your device to the corresponding output (folded down overview: V) on your PC. Use the video inputs for recordings. 42 THE GRAPHICS CARD The Sound Card Diagram reference: H1, I, J1, J2, T1, T2, U1, U2 Your PC has an integrated audio sound chip. It is compatible with industry standards Sound Blaster and Microsoft Sound System Version 2. 0. Note The speaker/headphones output is designed for active speaker systems or headphones. Passive speakers cannot be used or if they are the quality will be significantly reduced. You can make the necessary settings for configuring the loudspeakers, etc. You open the configuration program, to make user-defined settings, by means of the symbol on the right in the task strip. OPERATION 43 Appendix Help Operation Connecting Safety USB Port Diagram reference: E Note Devices connected directly to the USB bus should not draw more than 500 mA. The voltage output is protected by a fuse (Limited Power Source according to EN 60950). [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. [. . . ]