User manual MEDION VIDEO SENDER MD 9048

[. . . ] DocumentUK-ARG 16/07/03 19:16 Page 1 SAFETY ADVISES General Please read these instructions carefully before using the system, and always keep the operating instructions close to hand. Note the warnings in the operation instructions and always keep the operating instructions close to hand. [. . . ] Never use cleaning solutions that could damage the surface of the devices. Never spray cleaning fluids directly onto the devices. 1 Zeichnung Gerät 9048. FH11 Tue Nov 16 15:29:26 2004 Seite 2 DESCRIPTION OF THE AUDIO/VIDEO TRANSMITTER Audio/Videotransmission antenna 433 MHz antenna On/Off button 12 Volt input (AC adaptor) Infrated LED connector output Video input Audio input Channel selector DESCRIPTION OF THE AUDIO/VIDEO RECEIVER Audio/Videoreception antenna Channel selector 433 MHz antenna On/Off button 12 Volt input (AC adaptor) Audio input 75 antenna output Video input 2 DocumentUK-ARG 16/07/03 19:16 Page 4 HOW DOES THE SYSTEM OPERATE The transmitter sends an Audio/Video signal from the source to the receiver. This 2, 4 GHz signal can be broadcasted up to a 100 meters in free field and up to 30 meters indoors. The receiver converts the infrared signals sent by the remote control of the A/V source into 433 MHz radio frequency signals. The transmitter will then reconvert these signals into infrared signals in order to control the A/V device wanted. y t t t t A 4 Ins Infrared LED Original remote control of the Audio/Video source Receiver Transmitter T t 4 DocumentUK-ARG 16/07/03 19:17 Page 5 CONNECTING THE AUDIO/VIDEO TRANSMITTER 1. Insert the 3 plugs of the supplied Audio/Video cable into the inputs of your A/V transmitter, ensuring to match up the different colours. Plug the other end of your cable to the double scart plug, ; then connect the scart plug into the scart socket of the selected A/V source. Connect the 12 Volts input of the transmitter with the AC adaptor and then plug it into a standard 230 Volts electric socket. Connect the infrared cable at the back of the transmitter and put one of the LED on the infrared receiver of the A/V source. You have 2 more LEDs at your disposal to control 2 additional A/V appliances. It is however necessary that the 3 appliances are line-connected by scart cables. In this case, place the scart plug on the last A/V device of the chain. To use the A/V source device, you have to select it with its remote control. Straighten up the 433 MHz antenna. Installation example: Transmitter ATTENTION : IR-LED IR-LED IR-LED The double scart adaptor must be connected to the scart socket of the A/V source. [. . . ] Enquire about the options for environmentally-friendly disposal. 9 Seite KONF-INF. FH11 Fri Sep 09 16:07:46 2005 Seite 16 INFORMATION CONCERNING THE DECLARATION OF CONFORMITY Hereby, Medion AG declares that MD 9048 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. For further information concercing the Declaration of Conformity, please contact our Service Center. Tested to be used in all EU-countries. 0682 10 [. . . ]