User manual MINOURA HYPERMAG

[. . . ] HyperMag will fit any wheel between 26" and 27" include 700c. WARNING !Tandems may be used if balanced correctly. Remove all oils and moisture from the drive roller before use. Keep both hands on handlebars at all times and maintain a normal riding position. After you ride bicycle on the HyperMag trainer, remove all dirt and particles from the rear tire, so that you'll have effective braking on your future rides. ! Check the couplings supporting the rear hub for damage and cracks. [. . . ] The resistance unit is located behind the bike. 1 Loosen the knob bolt and lay down the resistance unit in order to make the space for the rear wheel enough. Loosen the hub clamping handle to make the clearance between the couplings wider. Place your bike in front of the HyperMag and pull back the bike between the frame pillars. Lift up the rear part of the bike and attach the left side hub (Q/R side) into the left coupling (see Fig. If the lever part of the skewer touches the edge of the coupling, it may be damaged and your weight will not be able to be supported safely. To avoid this problem, adjust the angle of the ring on the coupling to be that the lever will come to the horrow of the ring. (Fig. D) 3 ! Lift up the bike with using the left hub as the fulcrum and make the rear axle horizontal. Tighten the hub clamping handle and catch the right side (rear cog side) hub with the coupling. Harder clamping can supports the bike firmly, but over-tighten may cause a damage on your bike or HyperMag. Also you must confirm the stability of the bike everytime you use the HyperMag with shaking the bike slightly. 4 5 If you are the Type-R user, install the remote control device onto the handlebar. Lastly, tighten the knob bolt to press the drive roller to the tire. Be sure that you should stop thightening when the roller touches the tire, then tighten a half or 1 rotation more (see Fig. If the roller pressure to the tire is too weak or too strong, your tire may worn down incredibly easily. G) ADJUSTING THE LOAD LEVEL You can choose from 7 different load levels with shifting the adjusting dial (Type-D) or the remote shifter lever (Type-R). <INCREASING LOAD LEVEL> If your model is Type-D, turn the load adjusting dial to the direction of "H" symbol (see Fig. If your model is Type-R, twist the remote shifter lever to the direction of "H" symbol (see Fig. Be sure there will be remained minimum load resistance even you shift the lowest position (L). This is caused by the pressure of the drive roller to the tire. Increasing (Fig. F) ! Decreasing <DECREASING LOAD LEVEL> If your model is Type-D, turn the load adjusting dial to the direction of "L" symbol (see Fig. If your model is Type-R, twist the remote shifter lever to the direction of "L" symbol (see Fig. [. . . ] So you can expect always exact speed data even you use different size wheel on the HyperMag. If you use the Type-R, the HyperBrain can be installed onto the remote shifter device directly. The speed sensor of the HyperBrain is installed on the hole of the flywheel cover. [. . . ]