User manual MINOURA MAG-500

[. . . ] Remove all oils and moisture from the drive roller and the tire before use. Keep both hands on handlebars at all times and maintain a normal riding position. Check the couplings supporting the rear hub for damage and cracks (see Fig. [. . . ] If the tire touches either left or right side platic housing of the Mag unit (see Fig. D), you must adjust the Mag unit position by loosening two bolts beneath the Mag unit. Turn the micro adjust knob clockwise to bring the drive roller into contact with the rear tire. If the tire is compressed about 3mm by the roller, stop turning the knob. WARNING: Too much or too little contact between the tire and the roller can cause premature tire wear and possibly damage the drive roller. D) Using The Mag Unit The Magturbo unit has 7 different levels of load force, replicating actual riding resistance. The load settings range from high (H) to low (L) and can be adjusted via the white lever on the Magturbo unit or the lever on the thumb shifter device. The rider may also adjust the load force by shifting up or down among his gears, depending on the level desired. We recommend that you start with a medium to low load force and gradually work up, increasing force as muscled warm up. Increasing Load Force To increase the load force, move the white lever on the Mag unit toward the "H" symbol. E) If your Mag unit is a remote control type, turn the lever on your thumb shifter device toward the "H" symbol. E) L Decreasing Load Force To decrease the load force, move the white lever on Mag unit toward the "L" symbol. F) Be sure the lowest selection is not zero load, there still be a small level of force. If your Mag unit is a remote control type, turn the lever on your thumb shifter device toward the "L" symbol. (Fig. F) -3- ! You must not be riding the trainer when you are adjusting the white lever on the Mag unit for load force. [. . . ] If so, please adjust the tension with the following steps; Nut Plastic Cap Set the remote shifter lever at "H" position. Remove the remote shifter device 1 Cable from the handlebar and straighten the cable. 2 3 Remove the plastic cap located on the bottom of the cable. K) Hold the adjusting screw with your right hand and push it towards the direction of the outer cable, then adjust the nut with your left hand to make the wire tension properly. [. . . ]