User manual MINOURA W-300

[. . . ] In addition, this stand can be used as a bike display stand. Gear Lever Clamp Jaws Clamp Knob Upper Frame Tool Tray (option) Frame Knob Bolt Clamp Lever Lower Frame Leg Plate Leg Foot Adjuster IMPORTANT NOTE O X Do NOT use W-300 without clmaping the frame, otherwise the bike may fall off. Set the Plate Leg on proper position otherwise the stability will be compromised and cause the W-300 to tip during use. -1- HOW TO SET-UP YOUR W-300 1 Place the Lower Frame on the level floor and fully open the Leg. Attach the Plate Leg onto the bottom of the Lower Frame and secure it with supplied Knob Bolt. [. . . ] G) 5 If you purchased the optional "Tool Tray", insert it to the Upper Frame before inserting the Upper Frame into the Lower Frame, and tighten the knob bolt to fix the position and angle. H) The Tool Tray is made of steel plate, so you may be injured if you scratch the edge of the plate with your finger. If the pedal or something hits the tray during crank rotation, move the tray to be behind so its behind the stand frame. (Fig. I) 6 Insert the Clamp Jaws to the upper horizontal tube of the Upper Frame, insert the washer from the backside then tighten the knob nut. J) ! If you tighten the knob nut so tight, the clamp jaws may not rotate easily. The proper amount of tightening should be so the clamp jaws can rotate smoothly but without any looseness. J) HOW TO USE THE CLAMP W-300 has unique one lever operation system for both opening/shutting and adjusting the jaws. Please read the following operation manual carefully and use it effectively and safely. TO ADJUST THE JAWS When the clearance between the clamp jaws and the bike is too small, turn the adjuster knob on the lever anti-clockwise. When the clearance between the clamp jaws and the bike is too great, turn the adjuster knob on the lever clockwise. K) TO OPEN/SHUT THE JAWS Simply pull down the Clamp Lever, the jaws will open. L) Do NOT adjust the knob AFTER shutting the jaws because this operation will NOT securely hold your bike!When the turning the adjuster knob anti-clockwise with the lever in the open position, do NOT over-tighten or force the knob as this will damage the threads on the lever. When turning the adjuster knob clockwise with the lever in the open position, do NOT loosen the knob too much as this will unthread the lever and could damage the mechanism. TO ROTATE THE JAWS Push down the Gear Lever to unlock the clamp jaws, then grab and rotate the jaws. (Fig. L) HOW TO REPLACE THE CLAMP RUBBER 1 Remove both E-rings which hold the clamp rubber with a plier. [. . . ] R) 4 Stop tightening when the clearance between the roll nuts is apporoximately one inch (see Fig. S), and check if it becomes possible to set the bolt down completely in the horrow of the frame. 1 inch -5- (Fig. S) FOR MORE INFORMATION CONTACT: MINOURA JAPAN HEAD OFFICE 1197-1 Godo, Anpachi, Gifu 503-2305 JAPAN Phone (+81) 584-27-3131 / Fax (+81) 584-27-4258 Email : minoura@minoura. jp http://www. minoura. jp MINOURA NORTH AMERICA (for U. S. [. . . ]