User manual MITSUBISHI EY-3DGS-1U

[. . . ] When this product is being used by a child, the parent or guardian should check to ensure that the child's eyes are not becoming tired. Stop using the 3D Glasses immediately if you feel tired, discomfort, or any other abnormality. Continuing to use the 3D Glasses in such cases may cause you to feel unwell. Stop using the 3D Glasses if you can clearly see double images when viewing 3D content. [. . . ] When you wear it upside down or back to front, you can not get the correct 3D images. Using the 3D Glasses, it may be hard to see other displays such as that of a personal computer, digital clock and calculator. You can not get 3D images when you lie down, even when wearing the 3D Glasses. When using the device in Europe: COMPLIANCE NOTICE This device complies with the requirements of the EC Directive 2004/108/EC "EMC Directive" and 2006/95/EC "Low Voltage Directive". The electro-magnetic susceptibility has been chosen at a level that gains proper operation in residential areas, on business and light industrial premises and on small-scale enterprises, inside as well as outside of the buildings. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Changes or modifications not expressly approved by Mitsubishi could void the user's authority to operate this equipment. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This symbol mark is according to the directive 2002/96/EC Article 10 Information for users and Annex IV, and/or to the directive 2006/66/EC Article 20 Information for end-users and Annex II. Your MITSUBISHI ELECTRIC product is designed and manufactured with high quality materials and components which can be recycled and/or reused. This symbol means that electrical and electronic equipment, batteries and accumulators, at their end-of-life, should be disposed of separately from your household waste. If a chemical symbol is printed beneath the symbol shown above, this chemical symbol means that the battery or accumulator contains a heavy metal at a certain concentration. This will be indicated as follows: Hg: mercury (0, 0005%), Cd: cadmium (0, 002%), Pb: lead (0, 004%) In the European Union there are separate collection systems for used electrical and electronic products, batteries and accumulators. Please, dispose of this equipment, batteries and accumulators correctly at your local community waste collection/recycling centre. Information on Disposal in other Countries outside the European Union This symbol mark is only valid in the European Union. If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal. Environment care information for users in China This symbol mark is only valid in China. With the 3D Glasses and 3D Emitter, you can enjoy 3D images when you watch the 3D supporting programs on the projectors supporting 3D images. [. . . ] Check that there is no interference of the signals from other infra-red emission section. Not light up even if Replace the battery with a new one if the indicator does not the power button is light up even when you press the power button. When the 3D Glasses become dirty, wipe them with a soft and dry cloth. If you wipe them with a dirt cloth, the lens (liquid crystal shutter) or the infrared reception section may be damaged. [. . . ]