User manual MITSUBISHI PD-5065

[. . . ] Owner's Guide Mitsubishi Plasma Display PD-4265 & PD-5065 IMPORTANT SAFETY INSTRUCTIONS (PD-4265/PD-5065) Read before operating equipment Read these instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] Resetting the memory Use the and button to select the desired memory location, MEMORY1 to MEMORY6, then use the and buttons to select "RESET", and finally press the MENU/ENTER button. The memory is cleared, and "--" is displayed in the "INPUT", "SIGNAL" and "NOTE" columns. Inputting notes · Use the and buttons to select "NOTE", then press the MENU/ENTER button. · When you have finished inputting the note, press the MENU/ENTER button. 18 Reducing noise in the picture Use these settings if the picture has noise due to poor reception or when playing video tapes which have poor picture quality. Example: Setting "NR-3" Press MENU/ENTER button to access MAIN MENU. Use the buttons to select the PICTURE menu and then press the MENU/ENTER button. Use the buttons to change NR. PICTURE : OFF PICTURE MEMORY CONTRAST BRIGHTNESS SHARPNESS COLOR R TINT : OFF NR : MIDDLE COLOR TEMP. :2 GAMMA : AUTO LOW TONE : 0% SET UP LEVEL COLOR ADJUST : ON FILM MODE : NORMAL PICTURE MODE SEL. EXIT RETURN G NR : NR-3 Information NR * "NR" stands for Noise Reduction. The effect becomes stronger as the number increases (in the order NR-1 NR-2 NR-3). OFF: Turns the noise reduction function off. 19 Setting the color temperature Use this procedure to set color tone produced by the plasma display. Example: Setting "HIGH" Press MENU/ENTER button to access MAIN MENU. Use the buttons to select the PICTURE menu and then press the MENU/ENTER button. Use the buttons to change COLOR TEMP to HIGH. PICTURE : OFF PICTURE MEMORY CONTRAST BRIGHTNESS SHARPNESS COLOR R TINT : OFF NR : HIGH COLOR TEMP. :2 GAMMA : AUTO LOW TONE : 0% SET UP LEVEL COLOR ADJUST : ON FILM MODE : NORMAL PICTURE MODE SEL. EXIT RETURN Changing the Gamma Curve This feature adjusts the brightness of the midtone areas while keeping shadows and highlights unchanged. Example: Setting "2" Press MENU/ENTER button to access MAIN MENU. Use the buttons to select the PICTURE menu and then press the MENU/ENTER button. Use the buttons to decrease or increase GAMMA. PICTURE : OFF PICTURE MEMORY CONTRAST BRIGHTNESS SHARPNESS COLOR R TINT : OFF NR : MEDIUM COLOR TEMP. :2 GAMMA : AUTO LOW TONE : 0% SET UP LEVEL COLOR ADJUST : ON FILM MODE : NORMAL PICTURE MODE SEL. EXIT RETURN G G Information Setting the color temperature LOW: Redder MID LOW: Slightly red MEDIUM: Standard (slightly bluer) HIGH: Bluer Information GAMMA settings The picture becomes darker as the number increases (in the sequence of 1, 2, 3, 4). Adjusting the color to the desired level Use this procedure to adjust the white balance for each color temperature to achieve the desired color quality. Example: Adjusting the "GAIN RED" of "HIGH" color temperature Press MENU/ENTER button to access MAIN MENU. [. . . ] Proof of purchase date from an authorized MITSUBISHI dealer is required when requesting warranty service. Present your sales receipt or other document which establishes proof and date of purchase. THE RETURN OF THE OWNER REGISTRATION CARD IS NOT A CONDITION OF WARRANTY COVERAGE. However, please return the Owner Registration Card so that we can contact you should a question of safety arise which could affect you. [. . . ]