User manual MUSE M-01R

[. . . ] Before throwing any batteries away, consult your distributor who may be able to take them back for specific recycling. NOTES: - Do not mix different types of batteries or old batteries with new ones. - Never recharge the batteries , apply heat to them or take them apart. - In order to avoid leakage, always remove the batteries when unit will not be used for a long period of time. [. . . ] Plug the AC adaptor’s circular connector into the unit’s DC 6V jack. GB - 1 GB - 2 LISTEN TO THE RADIO BAND SELECTION Turn on the unit. AUTO SCAN TUNING Press AUTO SCAN button once, the unit will auto tune into the station and will stop once station being received. VOLUME & TONE CONTROL - Rotate the VOLUME control knob to your desired volume. USING ANTENNA - When listening to FM broadcasting, extend the ANTENNA and change its length and direction to find the position which gives the best reception. - When listening to MW broadcast, rotate the unit to find the position which gives the best reception. GB - 3 19 17 PLEASE READ THE INSTRUCTION CAREFULLY BEFORE OPERATING THE UNIT. LISTENING TO FM STEREO Press STEREO/DISPLAY button until stereo earphones for the listening. indicator appears in the display when using DELETE PRESET STATIONS DELETE SINGLE STATION 1. Press TUNING knob, the unit will display station frequency and pre-memory address (00~99), then rotate TUNING knob, find the station frequency and address which you will delete. button until the number address and “ “ indicator flash in the display. Press TUNING knob, the unit will display station frequency and pre-memory address. button until “ “ and “ “ indicator flash in the display. 3. Disconnect your auxiliary source from the LINE IN jack to switch back to listen to the radio. Note: If no audio signal input, the unit will turn off automatically within 5 minutes. SLEEP TIMER FUNCTION 1. In OFF mode, short press POWER/SLEEP button. Within 3 seconds rotate the TUNING knob to adjust your desired auto turn-off time:01, 05, 10, 15, 30, 45, 60, 75, 90, 120, 150, 180, 210, 240, 270, 300, 330, 360, 390, 420, 450 or 480 minutes. RESET PROCEDURE If the radio does not function and the solutions below do not resolve the problem, perform a ‘ reset ‘. To reset the M-088R, unplug the external adaptor(if one is being used) and remove the batteries from the battery compartment. Insert a pointed object, such as straightened paper clip, into the RESET hole on front of the radio and gently press and release . Assure that the radio has power (batteries installed or AC adaptor plugged in). If using an AC adaptor, assure that it is plugged into the house-hold outlet ( main socket) and into the radio’s DC socket. Assure that the batteries are not depleted. SELECT 12/24 FORMAT Factory default is 24HR format. To change 12HR format, turn off the unit and long press 12/24 button unit “12H” indicator flashes in the display. Press again the button to confirm your adjustment. STORING FAVORITE STATION Select your desired station, long press FAVORITE 1-5 buttons until “ P1~5 ” indicator flashing on the lower right corner, then press again the same button (FAVORITE 1-5) to confirm the setting. To listen to your favorite station, select the desired band (MW/FM1/FM2), then press FAVOURITE 1~5 buttons. In full power, the continuous listening of the player may damage the user’s hearing. CLOCK AND TIMER (ALARM) FUNCTION TIME SETTING With the unit turned off, hold down the TIME button until hour digit flashes in the display, then rotate TUNING knob to adjust hour. [. . . ] Press again the button to confirm your adjustment. STORING FAVORITE STATION Select your desired station, long press FAVORITE 1-5 buttons until “ P1~5 ” indicator flashing on the lower right corner, then press again the same button (FAVORITE 1-5) to confirm the setting. To listen to your favorite station, select the desired band (MW/FM1/FM2), then press FAVOURITE 1~5 buttons. In full power, the continuous listening of the player may damage the user’s hearing. CLOCK AND TIMER (ALARM) FUNCTION TIME SETTING With the unit turned off, hold down the TIME button until hour digit flashes in the display, then rotate TUNING knob to adjust hour. After setting hour, immediately press the TIME button, then minute digit flashes in the display, rotate TUNING knob to change minute. TIMER A & B SETTING Turn off the unit, long press the TIMER A button until hour digit flashes and “A” indicator appears on the display, then rotate TUNING knob to adjust hour. [. . . ]