User manual MUSE M-088-R

[. . . ] Release the button to confirm it as your selection, or press down again the FM1 SET/BAND button to select the next frequency range. Remark: During FM1 selected (76-90MHz) or (87-108MHz), MW frequency range will change to (522-1620kHz); If FM1 selected (88-108MHz), MW frequency will change to (520-1710kHz). 11 12 14 16 POWER SUPPLY Battery Operation 1. Before inserting the batteries, observe the polarities (+ and -) of the battery, then relate the polarities to the engraved diagram inside the battery compartment. [. . . ] - Do not use the unit immediately after transportation from a cold place to a warm place; condensation problem may result. - Do not place objects filled with liquids, such as vases, on the apparatus. - No naked flame sources, such as lighted candles, should be placed on the apparatus. - Attention should be drawn to the environmental aspects of battery disposal. - The battery shall not be exposed to excessive heat such as sunshine, fire or the like - Excessive sound pressure from earphones and headphones can cause hearing loss. - Under the influence of electrical fast transient or/and electrostatic phenomenon, the product may malfunction and require user to power reset. - The AC adaptor is used as the disconnect device and it shall remain readily operable. To be completely disconnected the power input, the AC adaptor of the apparatus shall be disconnected from the mains completely. The AC adaptor should not be obstructed or should be easily accessed during intended use. If at any time in the future you should need to dispose of this product please note that Waste electrical products should not be disposed of with household waste. Check with your Local Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive) Note: For weak station broadcasting, suggest to turn off the “Stereo” function. Note: After auto turn on the unit, only POWER/SLEEP button and SNOOZE / LIGHT button will work, other buttons will be locked, you can press the POWER/SLEEP button to discharge it. TO STOP THE ALARM *Press SNOOZE button to stop the alarm temporarily, the alarm will ring again in 10 min. The corresponding ” ” or ” ” indicator will flash on display when snooze function is activated. The alarm will be on the following day at the same time. WORKING WITH MEMORY Each band can store 100 stations, in total 300 station memories (MW/FM1/FM2) can be saved. TO STORE STATION INTO MEMORY Tune to your desired station, short press MEM. /DEL. The unit will pick up the next available memory address for you; or you can select your own desire memory address by rotating TUNING knob, then short press MEM. /DEL. [. . . ] Press again TIMER A button to confirm setting or wait for 3 seconds, it will automatically confirm the setting. TO TURN ON/OFF ALARM CLOCK FUNCTION Press TIMER A or TIMER B button to display ” ” or ” ” in the display. The unit will auto turn on at the preset time and frequency, and after 30 minutes it will automatically turn off. AUTO TUNING STORAGE (ATS) Turn on the unit, select band, hold down the AUTO SCAN/ ATS button until frequency changed and address indicator flashes in the display. [. . . ]