User manual MUSE ML-30 CR NATURE

[. . . ] Color light 3. Press button (2) twice to turn on the color light, then it will start to cycle different colors. 4. Press button (1) to stop at current color, press this button again to resume the cycle. 5. Press button (2) thrice to turn off the light. ML-30 CR User Manual LAMP CLOCK RADIO WITH SOUNDS OF NATURE LOCATION OF CONTROLS 1. : Brightness control of main light; Pause or start the cycle of the ambience color light 2. [. . . ] If no button is pressed after 5 seconds, it will return to clock display with “NAP” icon. When the Nap alarm is triggered, press NAP (8) to stop, “NAP” icon will disappear. To check the remaining time before the NAP alarm is triggered, press NAP button (8), ON/OFF (12), or button (3). To cancel NAP function before NAP alarm is triggered, press NAP button (12), adjust nap time to “00” by pressing or (13/14), it will return to clock display after 5 seconds, “NAP” icon disappears. MORE INFORMATION ATTENTION : To reduce the risk of electric shock, do not remove the cover. The lightening flash with arrowhead symbol within the triangle is a warning sign alerting the user of “dangerous voltage” inside the The exclamation point within the triangle is a warning sign alerting the user of important instructions accompanying the product. WARNING - To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. SETTING THE ALARM AND WAKE-UP MODE This unit allows two wake times and to set the main light to turn on automatically and progressively a certain time before the alarm triggers. To set the alarm time -Slide the setting mode switch (6) to (alarm1) or (alarm2) position, “AL 1” or “AL 2” will appear on display and the HOUR digit will flash. The time decrements or increments at a faster rate when you press and hold the buttons. -Press button (3) and the MINUTE digit will flash, press / (13/14) to adjust. To set the progressive light (with setting mode switch (6) on or position) -Press button (1) repeatedly to adjust the progressive light activated duration (OFF-05-10-15-20-OFF) before alarm triggers. NOTE: When set to “OFF”, the main light will remain switched off at wake-up, “ ” is not displayed. 3. When alarm time and progressive light settings are completed, slide the setting mode switch (6) to (lock) position. To select the alarm source (buzzer or radio/natural sound) - Press or button (11 or 10). 1st press:” ”/“ ” (wake up by buzzer) 2nd press: “ ”/” ” (wake up by radio/natural sound) 3rd press: alarm off NOTE: Waking up by FM/MW radio or natural sound depends on position (FMMW) of the sound mode switch. STOPPING THE ALARM The alarm is programmed to run for 59 minutes. Once the alarm 1 or alarm 2 is activated, corresponding alarm indicator “ ”/ ” ” or “ ”/” ” will flash on display, the main light will turn on automatically if progressive light is set for the alarm. (3): Press to stop the alarm temporarily, the alarm will trigger again 9 minutes later. “ ”/” ” or “ ”/” ” and “SNOOZE” flash on display (5). 2. ON/OFF (12): Press to stop the alarm and it will sound again 24 hours later. “ ”/” ” or “ ”/” ” remains displayed. 3. Press or “ ”/” or (11 or 10) repeatedly until the alarm indicator “ ” goes off . The alarm is turned off permanently, ”/” ” For indoor use only SLEEP FUNCTION In sleep mode, the audio will turn off automatically after a specified time. [. . . ] And that no object filled with liquids, such as vases, shall be placed on the apparatus. - Do not use your set immediately after transport from a cold place to a warm place, there may be condensation problems. - Make sure that you keep your set away from water and high temperatures. - To be completely disconnected the power input, the mains plug of the apparatus shall be disconnected from the mains completely. [. . . ]