User manual NAIM NAT05 XS ISSUE 1

[. . . ] Appropriate recycling and waste disposal helps conserve resources and protects the environment from contamination. Careful installation will help ensure that their full potential is achieved. It begins with some general installation notes and statutory safety warnings. It is important for both safety and performance that any standard cables supplied are not modified. [. . . ] Always switch amplifiers off and wait a minute before connecting or disconnecting any leads. Always use the power switch on the product rather than a mains outlet switch. A "thump" may be heard from the loudspeakers as power amplifiers are switched on. This is normal, will not cause any loudspeaker damage and does not point to any fault or problem. A mild "pop" may also be heard shortly after equipment is switched off. It is essential that repairs and updates are only carried out by an authorised Naim retailer or at the Naim factory. Many components are custom made, tested or matched and appropriate replacements are often unobtainable from other sources. Direct contact to Naim for service or update information should be made initially through Customer Services: Tel: Email: +44 (0)1722 426600 info@naimaudio. Naim equipment takes a considerable time to run in before it performs at its best. The duration varies, but under some conditions the sound may continue to improve for over a month. Better and more consistent performance will be achieved if the system is left switched on for long periods. It is worth remembering however that equipment left connected to the mains can be damaged by lightning. Please quote the product serial number (found on its rear panel) in all correspondence. In some circumstances, depending on where you live and the earthing arrangements in your home, you may experience radio frequency interference. Controls on broadcasting in some territories allow very high levels of radio frequency radiation and both the choice and exact siting of equipment may be critical. Susceptibility to radio frequency interference is related to the wide internal bandwidth necessary for high sound quality. It should be installed in its final location before connecting cables or switching on. ensure also that the system volume is turned down before switching on. A number of power supply upgrade options are possible for the NAT05 XS. a diagram illustrating the connection of one of these is shown in Section 7. Contact your local retailer or distributor for advice if necessary on power supply connection. Ideally the aerial should be mounted on the roof, clear of obstructions and as high as possible. [. . . ] Indicators stereo: Indicates that both a stereo signal is received and stereo operation is selected. The NAT05 XS will indicate that a power supply or link plug is incorrectly installed by flashing all four front panel buttons. If the mains voltage drops too far below its nominal level the tuner output will be muted and all four front panel buttons will illuminate. After the mains voltage recovers there will be a 2 second delay before the output returns to normal. [. . . ]