User manual NOKIA BH-209

[. . . ] Export Controls This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. All rights reserved. Introduction The Nokia Bluetooth Headset BH209 allows you to make and receive calls while on the move. You can use the headset with compatible mobile devices that support Bluetooth wireless technology. Also read the user guide for your mobile device, which provides important safety and maintenance information. [. . . ] Do not attempt to remove the battery from the device, as you may damage the device. If Chargers Check the model number of any charger before using it with this headset. The headset is intended for use with the AC-3, AC-4, and DC-4 chargers. 4 © 2007 Nokia. All rights reserved. charging does not start, disconnect the charger, plug it in again, and retry. The fully charged battery has power for up to 6 hours of talk-time or up to 150 hours of standby time. However, the times may vary with different compatible Bluetooth devices, usage settings, usage styles, and environments. When battery power is low, the indicator light quickly flashes twice about every 3 seconds. Pair the headset 1. Ensure that your phone is switched on and the headset is switched off. Press and hold the multifunction key until the indicator starts to flash quickly. Activate the Bluetooth feature on the phone, and set the phone to search for Bluetooth devices. Enter the passcode 0000 to pair and connect the headset to your phone. In some phones you may need to make the connection separately after pairing. 5 Switch the headset on or off To switch on, press and hold the multifunction key until the headset beeps four times and the indicator light is displayed. © 2007 Nokia. All rights reserved. English To switch off, press and hold the multifunction key for about 4 seconds. The headset beeps four times, and the indicator light is displayed briefly. If the pairing is successful, the headset appears in the phone menu where you can view the currently paired Bluetooth devices. When the indicator light flashes twice every 5 seconds, the headset is connected to the mobile device and ready for use. Basic use Place the headset on the ear To use the headset with the supplied earloop, insert the earloop into the small opening at the back of the headset (9). Slide the earloop over your ear (10), and gently plug the earpiece into your ear. To use the headset on the left ear, rotate the earloop so that the loop is to the left of the Nokia logo (Figures 7 and 8). Call handling To make a call, use your phone in the normal way when the headset is connected to your phone. If your phone supports last number redialing with the headset, press the multifunction key twice when no call is in progress. If your phone supports voice dialing with the headset, press the multifunction key when no call in progress, and proceed as described in the user guide of your mobile device. [. . . ] All rights reserved. 7 English To adjust the volume, use the volume keys on your mobile device. To switch the call between the headset and a compatible device, press and hold the multifunction key for about 2 seconds. Reset To reset the headset if it stops functioning, although it is charged, plug the headset into a charger. Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. [. . . ]