User manual NOKIA BH-606

[. . . ] Please check with your Nokia dealer for details. 2 © 2008 Nokia. All rights reserved. Export controls This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion contrary to law is prohibited. Introduction With the Nokia Bluetooth Headset BH-606, you can make and receive calls while on the move. Connections may be subject to interference from obstructions, such as walls, or other electronic devices. [. . . ] The fully charged battery has power for up to 8 hours of talk time or up to 280 hours of standby time. When the battery is discharged, the headset beeps every minute and the indicator light flashes quickly. headset beeps, and the indicator light is displayed. The headset beeps, and the indicator light turns off. Pair the headset 5 you may need to make the connection separately after pairing. When the headset is connected to your phone and is ready for use, the indicator light flashes about every 5 seconds. Basic use Place the headset on the ear Slide the earloop behind your ear, and point the headset toward your mouth (9 and 10). To use the headset on the left ear, detach the earloop (11), flip it, and push it into place (12). To activate voice dialling (if your phone supports this feature with the headset), when no call is in progress, press and hold the answer/end key for about 2 seconds. To set the headset volume, slide the volume key up or down. Calls To make a call, use your phone in the normal way when the headset is connected to it. To redial the number you last called (if your phone supports this feature with the headset), when 6 © 2008 Nokia. All rights reserved. To mute or unmute the microphone during a call, press the middle of the volume key. To switch a call between the headset and a compatible phone, press and hold the answer/end key (or the power key) for about 2 seconds. hold the answer/end key for about 2 seconds. To use these features, your phone must support the Bluetooth Hands-Free profile 1. 5, and call waiting (network service) must be activated in the phone. Clear settings or reset To delete the pairings from the headset, switch off the headset, and press and hold the power key and the answer/end key for about 5 seconds. To reset the headset if it stops functioning, even though it is charged, connect the headset to a charger that is connected to a wall outlet. Handle two calls To answer a waiting call and put the active call on hold, press and hold the answer/end key for about 2 seconds. To answer a waiting call and end the active call, press the answer/ end key. To end the active call and activate the call on hold, press the answer/ end key. To switch between the active call and the call on hold, press and Troubleshooting If you cannot connect the headset to your compatible phone, check that the headset is charged, 7 © 2008 Nokia. All rights reserved. switched on, and paired with the phone. Battery and charger information This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. This device is intended for use when supplied with power from the following chargers: AC-3, AC-4, AC-5, and DC-4. The exact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following: E, EB, X, AR, U, A, C, or UB. The battery can be charged and discharged hundreds of times, but it will eventually wear out. [. . . ] Likewise, the amount of time that the device is turned on and in the standby mode will affect its talk time. © 2008 Nokia. All rights reserved. 9 Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. [. . . ]