User manual NOKIA BLUETOOTH HEADSET BH-900

[. . . ] Export Controls This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. 10 Switch a call between the phone and headset. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Use the headset with several phones . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pair the headset with a compatible phone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] For availability of approved enhancements, please check with your dealer. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. 5 Get started Charge the battery This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. If charging does not start, disconnect the charger, plug it in again, and retry. When the battery is fully charged, the green indicator light is displayed. The fully charged battery has power for up to 8 hours of talk-time or up to 180 hours of standby time. However, the talk and standby times may vary when used with different mobile phones or other compatible Bluetooth devices, usage settings, usage styles, and environments. When the battery is running out of power, the headset beeps, and the red indicator light starts to flash. Switch the headset on or off To switch on, press and hold the power key. The indicator light turns blue when the headset is connected to your phone and ready for use. The headset beeps, and the red indicator light is displayed briefly. Pair the headset with a compatible phone 1. Activate the Bluetooth feature on the phone, and set the phone to search for Bluetooth devices. Enter the passcode 0000 to pair and connect the headset to your phone. In some phones you may need to make the connection separately after pairing. If the pairing is successful, the headset beeps and appears in the phone menu where you can view the currently paired Bluetooth devices. Disconnect the headset from the phone To disconnect the headset from your phone (for example, to connect the phone to another Bluetooth device), do one of the following: · Switch off the headset. · Move the headset more than 10 meters (30 feet) away from the phone. You do not need to delete the pairing with the headset to disconnect it. Reconnect the paired headset to your phone To connect the headset to your phone, switch on the headset, make the connection in the Bluetooth menu of your phone, or press and hold the answer/end key. You can set your phone to connect with the headset automatically when the headset is switched on. To do this in Nokia phones, change your paired device settings in the Bluetooth menu. Troubleshooting If you cannot connect the headset to your phone, do as follows: · Ensure that the headset is charged, switched on, and paired with your phone. · Ensure that the Bluetooth feature is activated on your phone. 7 Get started · Check that the headset is within 10 meters (30 feet) of your phone and that there are no obstructions between the headset and the phone, such as walls or other electronic devices. · To reset the headset if it stops functioning, although it is charged, plug the headset into a charger, and briefly press the power key and the middle of the volume key at the same time. This reset does not clear your settings (for example, pairing settings). 8 Basic use 3. Basic use Put the headset on the ear Place the headset over your ear in a comfortable position, and point it toward your mouth as shown in the figure. Sliding boom The sliding boom brings the microphone closer to your mouth, which improves the audio quality even when you talk at a lower volume or in a noisy environment. [. . . ] The phone that was first paired with the headset is the default phone. If the headset is switched on within 10 meters (30 feet) of several paired phones, the headset tries to connect to the default phone. If the headset cannot connect to the default phone, the headset tries to connect to the last used phone. If the headset cannot connect to this phone either, one of the other six paired phones can be connected to the headset. [. . . ]