User manual NOKIA MD-7W

[. . . ] Other product and company names mentioned herein may be trademarks or tradenames of their respective owners. Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice. To the maximum extent permitted by applicable law, under no circumstances shall Nokia or any of its licensors be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused. [. . . ] The speakers comply with the Bluetooth Specification 2. 0 + EDR that supports Advanced Audio Distribution Profile (A2DP) 1. 0 and Audio/Video Remote Control Profile (AVRCP) 1. 0. Check with the manufacturers of other devices to determine their compatibility with this device. All rights reserved. Getting started Parts The speakers contain the parts shown on the title page: power and Bluetooth indicator light (1), power key (2), speakers (3), volume key (4), stereo widening key (5), indicator light for stereo widening (6), power connector (7), audio connector (8), and speaker connection cord (9). Do not place credit cards or other magnetic storage media near the speakers, because information stored on them may be erased. Warning: Use only chargers approved by Nokia for use with this particular device. The use of any other types may invalidate any approval or warranty and may be dangerous. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. Connect to power The speakers can be powered by the supplied charger or four AA batteries. Connect to wall outlet To use the speakers with the charger, connect the charger to a Chargers wall outlet, and plug the charger Check the model number of any cable to the power connector. This device is intended for use when If you use rechargeable batteries supplied with power from the AC-4 with the speakers, the batteries are not charged by the charger. All rights reserved. Install AA batteries To install the batteries, ensure that the speakers are switched off, and press the release switch of the battery cover at the back of each speaker. To close the cover, insert the catch at the top of the cover into the corresponding slot on the speaker, and push the cover against the speaker until it snaps into place. During long periods where the speakers are not used, remove the batteries to prevent damage from battery leakage. When battery power is low, the orange indicator light starts to flash, and the speakers beep. To switch off, press the power key. The orange indicator light is briefly displayed. Connect the speakers You can connect the speakers to a compatible music device (such as a music player or mobile phone with a music player feature) using Bluetooth wireless technology or the supplied cable. To use a Bluetooth connection, the music device must support the A2DP Bluetooth profile. Pair and connect using Bluetooth wireless technology The following instructions apply for a mobile phone but the procedure is the same for a music player, except that you may not need to give the Bluetooth passcode. Ensure that the speakers are off and that the phone is on. Switch the speakers on or off To switch on, press and hold the power key until the white indicator light turns on. © 2007 Nokia. Press and hold the power key until the white indicator light starts to flash. Activate the Bluetooth feature on the phone, and set it to search for Bluetooth devices. Enter the Bluetooth passcode 0000 to pair and connect the speakers to the phone. In some phones you may need to make the connection separately after pairing. [. . . ] Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. High temperatures can shorten the life of electronic © 2007 Nokia. All rights reserved. 7 devices, damage batteries, and warp or melt certain plastics. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards. [. . . ]