User manual NOKIA TMR880

[. . . ] User Guide 9355653 Issue 3 DECLARATION OF CONFORMITY We, NOKIA CORPORATION declare under our sole responsibility that the product Nokia TMR880 is in conformity with the provisions of the following Council Directive:1999/5/EC. A copy of the Declaration of Conformity can be found at http://www. nokia. com/phones/declaration_of_conformity/. Copyright 2003-2005 Nokia. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited. Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. [. . . ] If the call is a one-way call, you can also answer it by pressing and holding the PTT key. Press or to end the call. Muting the ringing tone Press Silent or Options to mute the ringing tone. By pressing Options, the following options also become available: Answer and Reject. Rejecting a phone call To reject an incoming call and to send the caller the "line busy" tone, press . Copyright 2005 Nokia. Direct mode I Direct mode basics In direct mode, the radio operates without the network, so the radios are communicating directly with each other. Direct mode enables one-way calls both in the network coverage area and outside the network coverage area. Note: When direct mode is active, only those radio functions that do not require the use of the network can be used. For example, in direct mode you cannot send or receive status or text messages, make or receive network mode calls, use WAP or the data connection or activate fast menu items that require the use of the network. To use radio functions that require the use of the network, activate network mode and return to the network coverage area. Your radio has direct mode channels and each channel can have up to three groups. To receive a direct mode call that is made to the selected or a scanned group on the selected channel, the user must be in the coverage area of the transmitting radio. The radio coverage areas of different users can vary; even if you can hear a conversation, not all those speaking can necessarily hear you. For communication to be efficient, all the users should be within each other's radio coverage areas. Copyright 2005 Nokia. All rights reserved. 66 I Using direct mode Activating direct mode To activate direct mode, press Menu and select Settings, Phone settings, Active mode and Direct. You can also activate direct mode and network mode in the fast menu, see Fast menu on page 44. When you activate direct mode, the selected channel and group will be those that were last selected in direct mode. When you return to network mode, the selected folder and group will be those that were last selected in network mode. The bar above indicates the signal strength of the radio you are receiving communication from. The higher the bar, the stronger the signal and the better you can receive the communication. If a compatible direct mode gateway is available, is displayed in standby mode and the bar above indicates the signal strength of the gateway. If a compatible direct mode repeater is available, is displayed in standby mode and the bar above indicates the signal strength of the repeater. See Direct mode gateway and repeater on page 70. Copyright 2005 Nokia. All rights reserved. 67 Selecting direct mode channels and groups Up to 60 direct mode channels can be stored in your radio's memory. [. . . ] Hospitals or health care facilities may be using equipment that could be sensitive to external RF energy. Vehicles RF signals may affect improperly installed or inadequately shielded electronic systems in motor vehicles (e. g. electronic fuel injection systems, electronic anti-skid (anti-lock) braking systems, electronic speed control systems, air bag systems). Check with the manufacturer or its representative regarding your vehicle. You should also consult the manufacturer of any equipment that has been added to your vehicle. Copyright 2005 Nokia. [. . . ]