Detailed instructions for use are in the User's Guide.
[. . . ] Direzione Home/Office Via Jervis, 77 - 10015 Ivrea (ITALY) www. olivettilexikon. com
Copyright © 2001, Olivetti All rights reserved
January 2001
The manufacturer reserves the right to carry out modifications to the product described in this manual at any time and without any notice.
ENERGY STAR is a U. S. registered mark.
The ENERGY STAR program is an energy reduction plan introduced by theUnited States Environmental Protection Agency in response to environmental issues and for the purpose of advancing the development and utilization of more energy efficient office equipment.
The mark affixed to the product certifies that the product satisfies the basic quality requirements.
NOTE: The illustrations of the copier appering in this Operation Manual include the optional drawer.
The auto-shut-off time setting is between 15 and 120 minutes in the areas corresponding to the Swiss Energy 2000 Program area. Your attention is drawn to the following actions which could compromise the conformity attested to above, as well as the characteristics of the product: · · · incorrect electrical power supply; incorrect installation, incorrect or improper use or use not in compliance with the warnings provided in the User's Manual supplied with the product; replacement of original components or accessories with others of a type not approved by the manufacturer, or performed by unauthorised personnel.
d-Copia 15
COPIER OPERATION MANUAL
Please read the instruction handbook before using the copier. Keep it close to the copier for easy reference.
Please read the instruction handbook before using the copier. [. . . ] Margin mode
The image of the original is shifted to the right to make a margin for binding on the left side of the paper. The margin width can be set between 1 mm and 18 mm in 1 mm increments.
2
Press the Zoom (+) or Zoom (-) key and change the number to select the margin width.
* The margin mode requires the optional memory board. (See "Margin width" on page 6-6. )
3
Press the enter key or Margin key. The margin mode is now selected.
1
To change the margin width, press and hold the Margin key for 3 seconds. "F17" appears on the copy quantity display and, 2 seconds later, a margin width appears. If you do not wish to change the margin width, press Margin key and proceed to step 4.
4
Set the original(s). * Set the originals so that the top (left) side of the original is positioned at the rear side. Setting them in the wrong direction may cause the margin to appear in the incorrect position.
5-1
CHAPTER 5 FUNCTIONS
5
Press the Start key. Border erase mode
(1) Sheet Erase
Use for erasing shadows, lines, etc. , that appear around the edges of copies made from sheet originals. (a in the illustration is the width of erasing border. )
(2) Book Erase
Use for making neat copies from thick books. (a in the illustration is the width of erasing boarder. )
* The Sheet Erase mode requires the optional memory board. (See "Border width" on page 6-6. ) This initial value is common to the Book Erase mode.
* The Book Erase mode requires the optional memory board. (See "Border width" on page 6-6. ) This initial value is common to the Sheet Erase mode.
5-2
CHAPTER 5 FUNCTIONS
1
To change the erasing border width, press and hold the Border Erase key or Book Erase key for 3 seconds. "F18" appears on the copy quantity display and, 2 seconds later, a number appears. If you do not wish to change the erasing boarder width, press either key and proceed to step 4. The number displayed indicates the erasing boarder width as follows: 1: 6 mm 2: 12 mm 3: 18 mm
4
Set the original(s). * Set book originals as shown in the illustration below.
5 2
Press the Zoom (+) or Zoom (-) key and change the number to select the erasing border width.
Press the Start key. Copying will start.
3
Press the enter key, Border Erase key or Book Erase key. The Sheet Erase or Book Erase mode is now selected.
5-3
CHAPTER 5 FUNCTIONS
3. Layout copy
Two or four originals can be combined into a single copy. The borderline of each original can also be marked with a solid line or dotted line. (When setting the originals on the platen, originals are arranged in the order of 1, 2, 3 and then 4. ) * In the 4 in 1 mode, available modes differ depending on the orientation of the originals. [. . . ] Within 30 seconds (at room temperature of 25°C, humidity 65%RH) From energy saver mode: Within 10 seconds [priority to recovery], within 30 seconds [priority to power save] (at room temperature of 25°C, humidity 65%RH) Within 5. 5 seconds (A4, manual mode) Any ratio between 50 and 200% (in increments of 1%) 47 MB (up to approx. 250 A4 originals with a black ratio of 6% can be stored) Reading: 600 x 600 dpi Writing: 600 x 600 dpi Automatic feeding from the drawer (1 drawer, capacity 250 sheets [80g/m2/standard paper as specified by our company]) and multi-bypass (capacity 50 sheets [80g/m2/standard paper as specified by our company]) Drawer: Standard paper (64 - 80g/m2) Multi-bypass: Standard paper (45 - 160 g/m2), special paper (colored paper, transparencies, letterhead, etc. ), envelopes (COM-10, Monarch, DL, C5) [when using the printer function only] 1 - 250 sheets Rare gas lamp Dry process Heat roller Blade OPC Self-diagnosis function, energy save mode, auto exposure adjustment function, original size detection function, zoom copy mode, size zoom mode, photo mode, copy management function 220 - 240 V AC, 50 or 60 Hz, 2. 8 A (Average) Rated power consumption 1080 W Max. 41 kg < 70 dB (A) 891 mm (W) x 560 mm (D) ADF (automatic document feeder), drawer, job separator, key counter, memory board, printer board, printer network board, Original detection sensor
First copy speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Zoom ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]