User manual OMNICRON ELECTRONICS CONFERENCE MICROPHONE (PZ-2LA)
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual OMNICRON ELECTRONICS CONFERENCE MICROPHONE (PZ-2LA). We hope that this OMNICRON ELECTRONICS CONFERENCE MICROPHONE (PZ-2LA) user guide will be useful to you.
Manual abstract: user guide OMNICRON ELECTRONICS CONFERENCE MICROPHONE (PZ-2LA)
Detailed instructions for use are in the User's Guide.
[. . . ] PZ-2LA
DESCRIPTION
The Omnicron PZ-2LA Pressure Zone Microphone® is designed for meeting and conference recording. So that it does not draw attention, it looks like a switch, not a microphone. [. . . ] Connect it to the electronics circuit board at INPUT screw terminals # 1 and # 2. A balanced audio output is available at OUTPUT screw terminals # 2 and # 3. If the microphone is mounted to a grounded enclosure, ground loops could occur that would cause hum. If hum is present when the PZ-2LA housing is connected to ground, remove the resistor labeled GND LIFT on the printed circuit board (see schematic below). The microphone is factory set to handle sound levels up to 110 dB without excessive distortion. If the sound at the mic will exceed 110 dB, increase the value of the plug-in resistor (labeled Gain) for more headroom. To increase the gain, replacing the 1K ohm resistor with a 390 ohm resistor will provide 12 dB more gain with a corresponding decrease in headroom.
CUSTOM INSTALLATION
After removing the plastic housing, the microphone can be installed in a ceiling or wall using a standard electrical outlet box. Power from the 12VDC AC power adapter connects to INPUT terminals # 1 & # 2. If the audio output is connected to equipment that has a balanced input circuit with a separate ground connection, the ground connects to OUTPUT terminal # 1.
INSTALLATION
The PZ-2LA comes pre-wired for use with recorders that have a 3. 5mm "AUX" (auxiliary) input jack. It is supplied with a 6' cable that plugs into a supplied junction box. The junction box has an AC adapter which plugs into 120VAC to power the unit, and a 6' cable to connect audio output from the microphone to your recorder. Follow the directions supplied with your recorder for recording with the PZ-2LA microphone. [. . . ] The PZM® microphone used in the PZ-2LA is manufactured by Crown International, Inc.
1K
PZ-2LA Schematic diagram
C OMNICRON ELECTRONICS www. omnicronelectronics. com
02020098
581 Liberty Highway l P. O. Box 623 l Putnam, CT 06260-0623 l ((860) 928-0377 l FAX (860) 928-6477 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE OMNICRON ELECTRONICS CONFERENCE MICROPHONE (PZ-2LA)
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual OMNICRON ELECTRONICS CONFERENCE MICROPHONE (PZ-2LA) will begin.