User manual ONKYO HT-S7200

[. . . ] Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 AV Receiver Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 HT-RC160 Turning On & First Time Setup . . . . . 37 Instruction Manual Basic Operations. . . . . . . . . . . . . . . . . . . . . . . . . 50 Using the Listening Modes . . . . . . . . 59 Advanced Setup . . . . . . . . . . . . . . . . . . . . . . . . . . 66 Zone 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 82 Controlling Other Components . . . . 86 Thank you for purchasing an Onkyo AV Receiver. Please read this manual thoroughly before making connections and plugging in the unit. Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new AV Receiver. Please retain this manual for future reference. Others. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 97 En WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] Refer to your speaker's manuals to determine the optimum crossover frequencies. Subwoofer Front*1 Center*2 Surround*2 Front High*2*3*5*6 Surr Back*3*4*5*7 Surr Back CH*8 1ch: Select if only one surround back L speaker is connected. 2ch: Select if two (left and right) surround back speakers are connected (default). Full Band, 40Hz to 100Hz (default), 120Hz, 150Hz, 200Hz Full Band, 40Hz to 100Hz, 120Hz, 150Hz, 200Hz None: Select if no speaker is connected. 67 Advanced Setup--Continued LPF of LFE 80Hz, 90Hz, 100Hz (default), 120Hz (Low-Pass Filter for the LFE Channel) This setting is not set automatically by the Audyssey 2EQTM Room Correction and Speaker Setup function (see page 45). With this setting, you can specify the cutoff frequency of the LFE channel's low-pass filter (LPF), which can be used to filter out unwanted hum. Double Bass*9 This setting is not set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function (see page 45). With the Double Bass function, you can boost bass output by feeding bass sounds from the front left, right, and center channels to the subwoofer. Notes: *1 *2 *3 *4 *5 *6 *7 *8 *9 If the "Subwoofer" setting is set to "No", the "Front" setting is fixed at "Full Band". If the "Front" setting is set to anything other than "Full Band", "Full Band" cannot be selected here. If the "Surround" setting is set to "None", this setting cannot be selected. If the "Surround" setting is set to anything other than "Full Band", "Full Band" cannot be selected here. If the "Speaker Type" setting is set to "Bi-Amp" (page 42), or Powered Zone 2 is being used (page 83), this setting cannot be selected. If the "SurrBack/FrontHigh" setting is set to "SurrBack" (page 42), this setting cannot be selected. If the "SurrBack/FrontHigh" setting is set to "FrontHigh" (page 42), this setting cannot be selected. If the "Surr Back" Setting is set to "None" (page 67), this setting cannot be selected. This function can be set only if the "Subwoofer" setting is set to "Yes", and the "Front" setting is set to "Full Band". Speaker Distance This setting is set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function (see page 45). Here you can specify the distance from each speaker to the listening position so that the sound from each speaker arrives at the listener's ears as the sound designer intended. Range: 0. 3 to 9 meters in 0. 3-meter steps. Left, Front High Left, Center, Front High Right, Right, Surr Right, Surr Back R, Surr Back L, Surr Left, Subwoofer Specify the distance from the each speaker to your listening position. Note: Speakers that you set to "No" or "None" in the Speaker Configuration (page 67) cannot be selected. Notes: · The Center, Subwoofer and Front High distances can be set up to 5 ft. (6 m), the Center, Subwoofer, Front High Left and Front High Right distances can be set between 15 and 25 ft. · The Surround and Surround Back distances can be set up to 5 ft. [. . . ] Never Touch this Unit with Wet Hands--Never handle this unit or its connection cord while your hands are wet or damp. If water or any other liquid gets inside this unit, have it checked by your Onkyo dealer. For Canadian Models For models having a power cord with a polarized plug: CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. Modèle canadien Sur les modèles dont la fiche est polarisée: ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU FOND. About the UP-A1 With the UP-A1 connected to an Onkyo Universal Portcapable AV receiver, you can enjoy the music stored on your iPod*1 or iPhone*2 simply by inserting it into the UP-A1. And, you can charge your iPod or iPhone while listening to your music. Notes: · Before using the UP-A1, update your iPod or iPhone with the latest software, available from the Apple Web site at: www. apple. com · For the latest information on the UP-A1, see the Onkyo Web site at: www. onkyo. com · The instructions in this manual apply to the iPod and iPhone as of December 2008, and may change with future upgrades to the iPod or iPhone software. *1 iPod is a trademark of Apple Inc. , registered in the U. S. [. . . ]