User manual ONKYO R-805X

[. . . ] English FM STEREO/AM TUNER AMPLIFIER Before using R-805X Instruction Manual FM STEREO / AM TUNER AMPLIFIER INPUT ENERGY SAVE CD MD CDR LINE/DVD Connections Preparations VOLUME ACOUSTIC PRESENCE FM AM TAPE STANDBY / ON OFF / 1 / 2 / 3 PHONES DISPLAY MEMORY FM MODE PRESET CLEAR TUNING R-805X Operation FM STEREO / AM TUNER AMPLIFIER INPUT ENERGY SAVE CD MD CDR LINE/DVD VOLUME ACOUSTIC PRESENCE FM AM TAPE STANDBY / ON OFF / 1 / 2 / 3 PHONES DISPLAY MEMORY FM MODE PRESET CLEAR TUNING ACCUCLOCK R-805X Other Information Thank you for purchasing the ONKYO R-805X FM Stereo/AM Tuner Amplifier. Please read this manual thoroughly before making any connection or turning on the power. Follow these instructions to obtain optimum performance and maximum listening enjoyment from your new R-805X. Please retain this manual for future reference. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] When you press the ENERGY SAVE button: · The ENERGY SAVE indicator starts flashing. · The display scrolls words "ENERGY SAVE, " then turns off. When the power to other components is turned off, the Direct Play function is disabled. To turn on the power to the components again, press the STANDBY/ON button on the R-805X. (With a slight delay, the power to the components connected to the R-805X will be turned on. ) Energy Save mode is cancelled when you press the ENERGY SAVE button while the ENERGY SAVE indicator is flashing. 20 Preparing the remote controller Installing the remote controller batteries Using the remote controller Point the remote controller toward the remote control sensor. R-805X 1 Remove the battery compartment cover by pressing and sliding it away from the remote controller unit. Remote control sensor FM STEREO ENERGY / AM TUNER AMPLIFIER SAVE CD MD CDR LINE/DVD FM INPUT VOLUME STANDBY / ON AM TAPE ACOUSTIC PRESENC E PHONES MEMORY FM MODE CLEAR OFF / 1 /2/3 DISPLAY PRESET TUNING 30° R-805X 30° 2 Insert two AA-size batteries into the battery compartment. Carefully follow the polarity diagram (positive + and negative - symbols) inside the battery compartment. About 5 m (16 feet) Control range 3 After batteries are installed and seated correctly, replace the compartment cover. Notes · Do not mix new batteries with old batteries or different kinds of batteries. · To avoid corrosion, remove the batteries if the remote controller is not to be used for a long time. · Remove dead batteries immediately to avoid damage from corrosion. If the remote controller doesn't operate smoothly, replace both the batteries at the same time. · The life of the batteries supplied is about six months but this will vary depending on usage. Notes · Place the unit away from strong light such as direct sunlight or inverted fluorescent light which can prevent proper operation of the remote controller. · Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference. · Do not put any object such as a book on the remote controller. The buttons of the remote controller may be pressed by mistake and drain the batteries. Placing the unit behind such doors may prevent proper remote controller operation. · If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate. 21 Setting the Clock The "ACCUCLOCK" features an automatic clock adjusting function automatically sets the clock time by means of RDS broadcast signals. · The "ACCUCLOCK" feature is available only on the European model, and only in areas where RDS broadcasts are available. · Adjust the clock as explained in "Setting the clock manually" on page 24 if you are using U. S. or Canadian models or if you are using the unit in the area where RDS broadcasts are unavailable. · It may take about 5 minutes for the time information to be received and displayed after you plug in the power cord. After the clock is initially set, it will be adjusted periodically when the R-805X is in Standby mode (all input source indicators are turned off) or in ENERGY SAVE mode (the ENERGY SAVE indicator is lit). Notes on using the "ACCUCLOCK" function: · Make sure that your FM antenna has been properly connected as explained on page 18. It is strongly recommended that you install an outdoor FM antenna since the FM indoor antenna may not receive RDS broadcasts well enough to allow ACCUCLOCK to function properly. For more information, see page 25. ) · If RDS signals cannot be received, no RDS station will be found. [. . . ] stereo broadcasts will be heard in mono. ) No station or undes- · The power cord has been · The memory contents are lost if the unplugged for a long time. power is not turned on and off a ired station is few times each month. Store all starecalled when a Pretions in the memory again and set button is pressed. remember to turn the power on and off a few times each month. The RDS function · The station is not an RDS · Receive an RDS station. · Move the antenna as far away as possible from fluorescent lamps. [. . . ]