User manual ONKYO SKF-101

[. . . ] Loosen the LOW-FREQUENCY binding post screws, with the jumper bars attached. * To use banana-plug speaker cables, insert the banana plug into the center hole of each binding post. HIGH-FREQUENCY binding post LOW-FREQUENCY binding post Before using this unit The speaker cabinet is made of wood and is therefore sensitive to extreme temperatures and humidity. Avoid placing the speaker systems in locations subjected to direct sunlight, or in smokey or in humid places, such as near an air conditioner, humidifier, bathroom, or kitchen. [. . . ] Also, be sure to connect the Right and Left speakers with the amplifier's corresponding speaker terminals. Pull lightly on the speaker cables to ensure that they are connected firmly. Precaution on use This speaker system can handle the specified input power when it is used for ordinary music reproduction. If the following abnormal signals are fed to the speaker, however, an overcurrent may flow in the internal circuits, causing burning or breakage of the wires even if the input power is below the specified rating. High-frequency sound generated by an oscillator, an electronic musical instruments, etc. Sound produced when connecting or disconnecting audio connection cables (Always turn off the amplifier's power before connecting or disconnecting cables. ) 7. Howling when a microphone is used Do not place magnetic objects such as screwdrivers and iron parts near the tweeter since they use speakers with strong magnets. Otherwise, the objects may be attracted, causing injury or damaging the diaphragm. Use with a TV set In general, Braun tubes used for color television sets, etc. are extremely sensitive and can be affected even by the magnetism of the earth. If a speaker system is used near them, therefore, discoloration or distortion of pictures will occur. To allow use with color television sets, etc. , this speaker system is provided with magnetic shielding. Even so, discoloration may still result, depending on the installation environment. If discoloration occurs, turn off the power of the television set, wait for 15 to 30 minutes and then turn it on again. This activates the self-demagnetizing function of the television set, improving the display condition. If discoloration persists even after performing this remedy, move the speaker apart from the television set. Discoloration may also be caused when a magnet or other magnetizing object exists near the television because of the combined effect. Speaker care Your Onkyo speakers are finished with a very high quality polymer laminate covering that serves to protect the wood speaker cabinet. Wipe the cabinet periodically with a dry, silicon-embedded or plain soft cloth. The covering may be cleaned with a soft cloth moistened with water and a mild soap. Use a soft brush or hand vacuum cleaner to remove dust and lint from the grille material. Placement The sound quality a speaker system reproduces varies greatly depending on the construction and area of the room where it is installed, as well as the location and size of the furniture. Avoid placing the speaker system on an elevated object such as on concrete blocks. Also note that high-quality bass cannot be obtained if the speaker system is unstably positioned. [. . . ] In case of warranty claim, please report this number. Attaching and detaching the speaker grilles This speaker system uses detachable grilles. While holding the bottom edge of the speaker grille with your both hands, pull it gently toward you to remove the bottom of the grille. In the same way, gently pull the upper edge of the speaker grille toward you to remove it from the main unit. To replace the grill, push the projections at the corners into the grille plug holes on the speaker cabinet. Removal Replacement Sales & Product Planning Div. [. . . ]