User manual ONKYO TX-8410

[. . . ] REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Important Safeguards 1. Read Instructions ­ All the safety and operating instructions should be read before the appliance is operated. Retain Instructions ­ The safety and operating instructions should be retained for future reference. [. . . ] In this case, stop the playback of the source on the player for about three seconds and then resume playback. · You may not be able to play some DTS source signals from certain CD players and LD players even if you connect the player to the TX-8410 digitally. This is because the digital signal has been processed (such as the output level, sampling frequency, or frequency response) and the TX-8410 cannot recognize the signal as DTS data. Therefore you may hear noise when you play a DTS source while processing the signal. · The outputs for the VIDEO 1 OUT, VIDEO 2 OUT, TAPE OUT, output analog audio signals. · If a compact disc or LD encoded in the DTS format is played back with "PCM" selected, only noise will be produced. Always select "All" or "DTS" when playing back DTSencoded sources. Multichannel This sub-menu will not appear if AM or FM is selected at the front panel for the input source. This setting is normally set to "No, " and only needs to be changed to "Yes" if a DVD player, MPEG decoder, or other component that has a multi channel port is connected to the MULTI CHANNEL INPUT port for 5. 1-channel, 6. 1-channel, or 7. 1-channel audio. For example, if a DVD player is connected to the MULTI CHANNEL INPUT port, then select DVD at the front panel as the input source, bring up this sub-menu, and select "Yes" for the Multichannel setting. You can only select Multichannel with the AUDIO SELECTOR button when "Yes" is selected here. Direct This mode delivers pure sound with minimum sound quality adjustment and filtration. The sound recorded for the right and left front channels is output to the right and left front speakers only and not output to the subwoofer. Mono Movie This mode is suitable for playing back monaural recording such as old movie soundtracks. The center channel delivers the unprocessed original sound, whereas the other channels deliver the center-channel sound processed with the appropriate reverberation. This allows you to enjoy monaural sound with the atmosphere of a movie theater. Surround modes With this mode, decoding is performed automatically to match the input signal. · DOLBY DIGITAL Surround, DTS (Digital Theater System) Surround This 5. 1-channel digital surround format enables you to individually record and play five full-range (20Hz­20kHz) channels (left and right front, center, two surround channels) plus an LFE channel (Low Frequency Effect) for the lowrange effect sound. It will create a realistic sound that could be heard in the theaters and concert halls. Dolby D (Dolby Digital) This mode is for listening to sources encoded in the Dolby Digital format. Dialog normalization (Dialog Norm) Dialog normalization is a feature of Dolby Digital. With this function, for example, if "Dialog Norm: +4" is displayed while playing back a Dolby Digital source, it means that that source material was recorded 4 decibels higher than normal. [. . . ] · Stereo FM broadcasts cover only about half the distance of an ordinary broadcast. © Change the position or direction of the outdoor antenna. No preset station is recalled. · Power cord has been unplugged or the POWER switch has been turned off for a long time. Store all stations again. 71 Troubleshooting guide REMOTE CONTROLLER Front panel controls function but remote controller controls do not. · No batteries in remote controller. · Remote controller is not pointed at the remote sensor of the TX-8410. [. . . ]