User manual ONKYO TX-DS494
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ONKYO TX-DS494. We hope that this ONKYO TX-DS494 user guide will be useful to you.
You may also download the following manuals related to this product:
ONKYO TX-DS494 (2323 ko)
ONKYO TX-DS494 (2300 ko)
Manual abstract: user guide ONKYO TX-DS494
Detailed instructions for use are in the User's Guide.
[. . . ] Contents
Before using
AV Receiver
Important Safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
TX-DS494
Facilities and connections
Instruction Manual
Front panel facilities . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Tighten the screw.
Connecting a subwoofer
Use the SUB WOOFER PRE OUT jack to connect a subwoofer with a built-in power amplifier. If your subwoofer does not have a built-in amplifier, connect an amplifier to the SUB WOOFER PRE OUT jack and the subwoofer to the amplifier.
Connecting to SPEAKERS A
Subwoofer
Front right speaker
Front left speaker
Center speaker
Surround right speaker
Surround left speaker
ANTENNA
SUB WOOFER PRE OUT
MONITOR OUT
DVD VIDEO 1
VIDEO 2 S VIDEO
R
L
R
OUT AM
L
IN IN IN
TAPE
IN FM 75
DIGITAL INPUT
MONITOR OUT OPTICAL
R
L
CENTER SPEAKER
REMOTE CONTROL
SURROUND SPEAKERS
COAXIAL
1
2
A
AC OUTLETS
AC 120V 60Hz SWITCHED TOTAL 120 W 1A MAX.
DVD
IN
FRONT
GND VIDEO 1
IN
R
SURR
L L B
AV RECEIVER
MODEL NO. TX-DS 494
PHONO
CD VIDEO 2
OUT
R
L R
IN SUB WOOFER
CENTER
R
L
VIDEO
MULTI CHANNEL INPUT
R
L
FRONT SPEAKERS
Connecting to SPEAKERS B
Front right speaker Front left speaker
17
Connecting antennas
To the use the tuner of TX-DS494, it is necessary to prepare the supplied FM and AM antennas. · Adjustment and placement of the FM and AM antennas for better reception must be done while listening to a station broadcast. · If better reception cannot be obtained, then placement of an outside antenna is recommended.
2. Insert the bottom edge of the outer frame into the groove on the stand.
Insert into the groove.
3. Strip away the insulation from the end of the cord.
FM indoor antenna
Connecting the AM loop antenna 1. Fully insert the stripped end of the cord.
ANTENNA
SUB WOOFER PRE OUT
R
OUT AM
L
2. Insert the end of the cable into the hole.
TAPE
IN FM 75
MONITOR OUT
DVD
IN
VIDEO
3. Release the lever.
The lever will return to the original position.
Except for North American models:
Fully insert the end of the cord.
AM loop antenna
ANTENNA SUB WOOFER PRE OUT
R
OUT AM
L
TAPE
IN FM 75
MONITOR OUT
ANTENNA
SUB WOOFER PRE OUT
DVD
IN
R
OUT AM
L
VIDEO
TAPE
IN FM 75
MONITOR OUT
The FM indoor antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion. If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended.
DVD
IN
VIDEO
Assembling the AM loop antenna 1. Rotate the outer frame of the antenna.
Either of the split ends of the AM antenna can be connected to either terminal. Unlike speaker cabling, there is no polarity for AM broadcast signals. Set it in the direction and position where you receive signals clearly. Put it as far away as possible from the TX-DS494, televisions, speaker cables, and power cords. When reception is not satisfactory with the attached AM loop antenna alone, connection of an outdoor antenna is recommended.
18
Connecting antennas
If the reception condition cannot be improved by adjusting the provided antenna, install an outdoor antenna and connect it to this unit.
4. Cut the ferrite core wire.
Cut the ferrite core wire with nippers, etc.
Connecting an FM outdoor antenna
Please make sure that you follow the considerations: · Keep the antenna away from noise sources (neon signs, busy roads, etc. ). · To avoid the risk of lightning and electrical shock, grounding is necessary. Follow item 14 of the "Important Safeguards" on page 2 when you install the outdoor antenna.
FM outdoor antenna
Distribute the wire along the groove.
5. Reinstall the cover.
The cover
ANTENNA
SUB WOOFER PRE OUT
Connecting the 300 ribbon wire 1. [. . . ] © Install an FM outdoor antenna as far as possible from the road (page 19). © Change the position or direction of the outdoor antenna.
RC-444M remote controller does not operate Onkyo DVD player properly (North American models only).
· Pre-programming code is improper. © Change the pre-program code (page 32).
OTHER LATE NIGHT function cannot be used.
TUNED and STEREO indicators light on but sound is distorted and stereo separation is bad.
· Station is too strong. · Multiple reflection of the radio waves because of tall buildings or mountains. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ONKYO TX-DS494
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ONKYO TX-DS494 will begin.