User manual ONKYO TX-DS747

[. . . ] 17 Setup and operation Speaker setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 Listening to RDS broadcasts (European models only) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Enjoying music or videos with TX-DS747 . . . 33 Remote controller Thank you for purchasing the Onkyo AV Receiver. Please read this manual thoroughly before making connections and plugging in the unit. [. . . ] If it displays the listening mode, press the DISPLAY button to display the frequency. 2. "PRESET IN?" appears in the front display for about five seconds. PRESET MEMORY 2. Press the PRESET / button and select the number of the desired preset station. The MEMORY indicator lights red. "MEMORY" (Lights red) DSP / MODE ADJ 2. Press the CH button and select the number of the desired preset station. MEMORY Erasing a preset radio station 1. Press the AM or FM button and press the PRESET / button to select the preset radio station that you want erase (see above). ch 4. Turning the jog dial, select a preset number (from 1 to 40) to assign the station to be preset. "MEMORY" (Lights red) Flash TUNED MEMORY DSP / MODE ADJ PUSH TO ENTER 2. · Up to 40 stations can be stored in memory as preset radio stations. DSP / MODE ADJ 3. Turn the jog dial to display "PRESET ERASE?" PUSH TO ENTER ch DSP / MODE ADJ PUSH TO ENTER 4. The selected preset station is erased. DSP / MODE ADJ PUSH TO ENTER 22 Listening to RDS broadcasts (European models only) Listening to RDS broadcasts RDS reception is available only on the European model and only in areas where RDS broadcasts are available. RDS was developed within the European Broadcasting Union (EBU) and is available in most European countries. It will then stop briefly at that station before continuing on until it reaches the next station. If you press the RT/PTY/ TP while "NONE" is displayed, "PTY ?" will appear. Press the jog dial when it reaches the station that you want to listen to. "NOT FOUND" will appear when no RDS signal is being received from the station. DSP / MODE ADJ PUSH TO ENTER · If the current station you are listening to is not an RDS station, only the frequency of the station appears. · If "WAITING" appears on the display, more time is required to receive the RT information. When the information is received, the characters will scroll across the front display. · If "NO TEXT DATA" appears on the display, RT information is not available. · The display shows the frequency for 3 seconds and returns to program service name. DSP / MODE ADJ PUSH TO ENTER Performing a TP scan 1. The current program type appears on the display. RT/PTY/TP "< TP >" will appear if the current station is broadcasting TP signals. The TX-DS747 will scan until it reaches a station broadcasting traffic information. If "NOT FOUND" appears on the display, a TP station cannot be located. DSP / MODE ADJ 3. [. . . ] · Center speaker is set to "NONE. " © Set CENTER to "LARGE" or "SMALL" (page 19). · Subwoofer is set to "NO. " © Check the speaker setting (page 19). © Check the output level of the Subwoofer using the test tone (page 19). 50 Troubleshooting guide No preset station is recalled. · Power cord has been unplugged or the POWER switch has been turned off for a long time. [. . . ]