User manual ONKYO TX-L5

[. . . ] Contents Before Using Your AV Receiver 2 AV Receiver TX-L5 Instruction Manual Getting started Turning on the AV Receiver/ Speaker Setup Enjoying music or videos Enjoying Surround mode/ Recording Thank you for purchasing the Onkyo AV Receiver. Please read this manual thoroughly before making connections and turning on the power. Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new AV Receiver. Please retain this manual for future reference. Other WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] Tighten the screw. Press and hold the lever. Insert the stripped end of the cable. By releasing the lever, the lever is replaced. ­ Front speakers ­ Right ch. Left ch. Center speaker Active subwoofer ­+ ­+ ­+ DVD/CD IN VIDEO 1 OUT IN VIDEO 2 IN MON OUT DVD/CD IN VIDEO 1 OUT IN VIDEO 2 MON OUT IN REMOTE CONTROL SUB WOOFER DIGITAL INPUT DVD (OPTICAL) VIDEO SURROUND SPEAKERS L R CENTER SPEAKER FRONT SPEAKERS R L S VIDEO IN OUT IN IN OUT IN OUT IN PRE OUT VIDEO 2 (COAXIAL) HD (OPTICAL) L AUDIO R DVD/CD VIDEO 1 VIDEO 2 HD MD/TAPE L ANTENNA AV RECEIVER TX-L5 R AM FM 75 DO NOT connect the power cord (mains lead) at this time. Surround speaker Right ch. Surround speaker Left ch. ­+ ­+ 15 Making Antenna (Aerial) Connections Connecting the Supplied FM and AM Indoor Antennas (Aerials) DVD/CD IN VIDEO 1 OUT IN VIDEO 2 IN MON OUT DVD/CD IN VIDEO 1 OUT IN VIDEO 2 MON OUT IN REMOTE CONTROL SUB WOOFER DIGITAL INPUT DVD (OPTICAL) VIDEO SURROUND SPEAKERS L R CENTER SPEAKER FRONT SPEAKERS R L S VIDEO IN OUT IN IN OUT IN OUT IN PRE OUT VIDEO 2 (COAXIAL) HD (OPTICAL) L AUDIO R DVD/CD VIDEO 1 VIDEO 2 HD MD/TAPE L ANTENNA R AM FM 75 DO NOT connect the TX-L5 power cord (mains lead) at this time. AV RECEIVER North American models: 1 Strip away the insulation from the end of the cord. FM indoor antenna (aerial) 2 Fully insert the stripped end of the cord. Except for North American models: Fully insert the end of the cord. ANTENNA AM FM 75 I Adjusting the position of the FM indoor antenna (aerial) The FM indoor antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion. If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended. Rotate the outer frame of the antenna. Insert into the hole. Extend the antenna cord. AM indoor antenna (aerial) Note Insert one end of the AM antenna (aerial) cord to either of the AM antenna (aerial) connectors and the other end to the other connector. There is no difference between one end of the AM antenna (aerial) cord and the other end, unlike the speaker cables which have positive and negative poles. Press up and hold the lever. Insert the end of the cord. Release the lever to secure the connection. ANTENNA AM FM 75 I Adjusting the position of the AM indoor antenna (aerial) The AM loop antenna is for indoor use only. Set it in the direction and position where you receive signals clearly. Put it as far away as possible from the TX-L5, televisions, speaker cables, and power cords. When reception is not satisfactory with the attached AM loop antenna alone, connection of an outdoor antenna is recommended. 16 Connecting an FM Outdoor Antenna (Aerial) If the FM reception is not very clear with the supplied antenna (aerial), connect an FM outdoor antenna (aerial) instead of the indoor FM antenna (aerial). FM outdoor antenna (aerial) Connecting coaxial cable to a 75/300 ohm antenna (aerial) adapter* 1 Strip the end of the coaxial cable. 15 mm 636 mm mm mm 1/4 1/8 1/4 3 Remove the transformer wire A from slit B and insert it into slit C. ANTENNA Slit B AM FM 75 in. in. 5/8 in. in. Slit C Wire A Connecting 300 ohm ribbon wire to a 75/300 ohm antenna (aerial) adapter* Loosen the screws and wrap the wire around these screws. Tighten Loosen 6 Reinstall the cover. 2 With your fingernail or a small screwdriver, press the stoppers outward and remove the cover. 4 Insert the end of the cable. 4 5 * (European, USA and Canadian models) Not supplied (Other models) Notes · · · · Supplied Install the antenna (aerial) well away from tall buildings and in an area where FM stations can directly be received. Keep the antenna (aerial) away from noise sources (neon signs, busy roads, etc. ). To avoid the risk of lightning and electrical shock, grounding is necessary. Follow item 14 of the "Important Safeguards" on page 2 when you install the outdoor antenna (aerial). Connecting an AM Outdoor Antenna (Aerial) An outdoor antenna (aerial) will be more effective if it is stretched horizontally above a window or outside. Leave the supplied AM indoor antenna (aerial) connected. Note To avoid the risk of lightning and electrical shock, grounding is necessary. Follow item 14 of the "Important Safeguards" on page 2 when you install an outdoor antenna (aerial). ANTENNA Outdoor antenna (aerial) AM indoor antenna (aerial) AM FM 75 I Directional Iinkage Do not use the same antenna (aerial) for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each other. If you must use a common FM/TV (or VCR) antenna (aerial), use a directional linkage type splitter. Directional linkage type splitter To AV Receiver To TV (or VCR) 17 Connections for remote control (z) You can use the remote controller of this receiver to operate the z-connected Onkyo DVD player, CD player, MD recorder or cassette tape deck using the z cable provided with them (refer to page 27). Notes Example: Onkyo DVD Player DV-L5 VIDEO OUTPUT Y MONO DIGITAL OUTPUT OPTICAL COAXIAL REMOTE CONTROL W CB L CR VIDEO S VIDEO COMPONENT R ANALOG OUTPUT REMOTE CONTROL MONO L · When the DVD player, CD player or MD recorder connected to with the TX-L5 through z cable is turned on, the TX-L5 automatically turns on and selects the source that was turned on. (Auto Power On) · Turning the TX-L5 off sets the z-connected DVD player, CD player or MD recorder to standby mode. [. . . ] · No sound is reproduced from the center speaker when the listening mode is "STEREO" or "ORCHESTRA. " · Adjust the volume level of the center speaker. · Check that the selected speaker configuration includes the center speaker. · Check the connection between the AV receiver and the speaker, or set the speaker configuration to the 2 ch or 4 ch. If not recovered, disconnect the power cord (mains lead), then connect it again. [. . . ]