User manual ONKYO TX-SR577

[. . . ] Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 AV Receiver Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 TX-SR507 TX-SR577 Instruction Manual Turning On & First Time Setup . . . 36 Basic Operations. . . . . . . . . . . . . . . . . . . . . . . . . 45 Using the Listening Modes . . . . . . . . 59 Advanced Setup . . . . . . . . . . . . . . . . . . . . . . . . . . 66 Zone 2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80 Controlling Other Components. . . 84 Thank you for purchasing an Onkyo AV Receiver. Please read this manual thoroughly before making connections and plugging in the unit. Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new AV Receiver. Please retain this manual for future reference. Others. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93 En WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] PLAYLIST [ ]/[ ] buttons Selects the previous or next playlist on the iPod. UP-A1 series Dock is connected Status messages Note: In case of a transmission error without a status message appearing in the front panel, check the connection to your iPod. UP-A1 series Dock in connection with the check This unit is in the middle of recognizing the connection with your iPod. UP-A1 series Dock does not support the control Your iPod is properly stationed in a UP-A1 series Dock connected to the UNIVERSAL PORT jack of this unit, and the connection between your iPod and this unit is complete. When connection is confirmed, "UP-A1" is displayed for about 8 seconds. UP-A1 series Dock is not connected Your iPod was removed from a UP-A1 series Dock connected to the UNIVERSAL PORT jack of this unit. Station your iPod back in a UP-A1 series Dock connected to the UNIVERSAL PORT jack of this unit. 57 Recording This section explains how to record the input source and how to record audio and video from separate sources. Notes: · The surround sound and DSP listening modes cannot be recorded. · Sources connected to the analog multichannel input cannot be recorded. · DTS signals will be recorded as noise, so don't attempt analog recording of DTS CDs or LDs. · While the Pure Audio listening mode is selected, the VCR/DVR OUT V jack don't output video signal, so select another mode when recording. Recording from Different AV Sources You can overdub audio onto your video recordings by simultaneously recording audio and video from two separate sources. This is possible because only the audio source is switched when an audio-only input source, such as TV/TAPE, TUNER, or CD, is selected, the video source remains the same. In the following example, audio from the CD player connected to the CD IN and video from the camcorder connected to the AUX INPUT VIDEO jack are recorded by the VCR connected to the VCR/DVR OUT jacks. Recording the Input Source Audio sources can be recorded to a recorder (e. g. , cassette deck, CDR, MD) connected to the TV/TAPE OUT jack. Video sources can be recorded to a video recorder (e. g. , VCR, DVR) connected to the VCR/DVR OUT jacks. See pages 22 to 35 for hookup information. Camcorder video signal audio signal 1 Use the input selector buttons to select the source that you want to record. See "Which Connections Should I Use?" on page 23 to see which signals can be output and recorded. Remote controller You can watch the source while recording it. The AV receiver's MASTER VOLUME control has no effect on recording. CD player VCR 1 2 3 On your recorder, start recording. On the source component, start playback. Prepare the camcorder and CD player for playback. This selects the CD player as the audio source but leaves the camcorder as the video source. Start recording on the VCR, then start playback on the camcorder and CD player. Video from the camcorder and audio from the CD player are recorded by the VCR. 2 3 4 5 Note: If you select a different input source during recording, that input source will be recorded instead. 58 Using the Listening Modes Selecting the Listening Modes For a description of each listening mode, see "About the Listening Modes" on page 64. · The Dolby Digital and DTS listening modes can only be selected if your DVD player is connected to the AV receiver with a digital audio connection (COAXIAL, OPTICAL, or HDMI). [. . . ] · Make sure you've entered the correct remote control code (page 84). Can't control other components · Make sure you've selected the correct remote controller mode. · If you've connected an -capable Onkyo MD recorder, CD recorder, or RI Dock to the TV/TAPE IN/OUT jacks, or an RI Dock to the CBL/SAT IN or VCR/DVR IN jacks, for the remote controller to work properly, you must set the Input Display to "MD", "CDR", or "DOCK", respectively (see page 44). If more than one code is listed, try each one. 95 Troubleshooting--Continued Recording Can't record · On your recorder, make sure the correct input is selected. [. . . ]