User manual ONKYO TX-SV535

[. . . ] 91 En WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Important Safety Instructions 1. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] Repeat this procedure for all of your favorite AM/FM radio stations and XM channels. Deleting Presets 2 MASTER VOLUME STANDBY/ON STANDBY ZONE 2 POWER ON OFF PURE AUDIO MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 PHONO TAPE TUNER CD DISPLAY PHONES ZONE 2 OFF TONE STEREO DIMMER MEMORY TUNING MODE VIDEO 4 INPUT SETUP RETURN ENTER SETUP MIC LISTENING MODE ZONE 2 LEVEL CLEAR PRESET TUNING PRESET DIGITAL S VIDEO VIDEO L AUDIO R 1 2 TUNING MEMORY MODE CLEAR Select the preset that you want to delete. While holding down the [MEMORY] button, press the [TUNING MODE] button. The preset is deleted and its number disappears from the display. 56 Using the Multichannel DVD Input Multichannel DVD Input Settings 1 ON STANDBY I RECEIVER TV INPUT V1 V2 V3 1 V4 2 MULTI CH 3 DVD + T V CH MULTI CH 4 CD 5 TAPE 6 TUNER - While the DVD input is selected, press the [RECEIVER] REMOTE MODE button, followed by the [SETUP] button. The main menu appears onscreen. 7 PHONO 8 0 MACRO 9 T V VOL CLEAR 12 +10 11 --/--- 10 INPUT SELECTOR 1 2 3 ZONE2 2 ENTER REMOTE MODE RECEIVER RECEIVER TAPE/AMP TV DVD CD HDD Use the Up and Down [ ]/[ ] buttons to select "4. The Multichannel Analog menu appears. 4-3. MULTICH -----------DVD---------3. XM Antenna Aiming a. Input Channel:5. 1ch b. Subwoofer Sensitivity : 0dB VCR CABLE CDR SAT MD DIMMER P TO MEN U MEN U SLEEP ENTER + CH DISC ALBUM ENTER VOL PREV CH DISPLAY RE TU R ENTER N SE T UP SETUP MUTING REC PLAYLIST RANDOM LISTENING MODE STEREO REPEAT PURE A SURR AUDIO DIRECT SUBTITLE PLAY MODE THX ALLST TEST TONE CH SEL LEVEL LEVEL OPEN/CLOSE VIDEO OFF L NIGHT Re-EQ 3 ENTER Using the Multichannel DVD Input The multichannel DVD input is for connecting a component with a 5. 1/7. 1-channel analog audio output, such as a DVD player, DVD-Audio/SACD-capable player, or an MPEG decoder. See page 28 for hookup information. RECEIVER Use the Up and Down [ ]/[ ] buttons to select the settings, and use the Left and Right [ ]/[ ] buttons to change them. Setup closes. 4 MULTI CH 5 Press the [RECEIVER] REMOTE MODE button, followed by the [MULTI CH] button. Audio from the multichannel DVD input will now be used for the DVD input source. MULTI CH indicator Input Channel If you've connected a 7. 1-channel audio output to the multichannel DVD input, select 7. 1ch. If you've connected a 5. 1-channel audio output, select 5. 1ch. Subwoofer Sensitivity Some DVD players output the LFE channel from their subwoofer output at 15 dB higher than normal. Note that this setting only affects signals connected to the SUBWOOFER input jack of the multichannel DVD input. If you find that your subwoofer is too loud, try the +10 dB or +15 dB setting. Note: · While the multichannel DVD input is selected, the Speaker Configuration settings on page 70 are ignored, and signals from the multichannel DVD input are fed to the subwoofer, front left, front right, center, surround left, surround right, surround back left, and surround back right speakers as they are. 57 Common Functions This section explains functions that can be used with any input source. V1 V2 V3 Adjusting Speaker Levels You can adjust the volume of each speaker while listening to an input source. LISTENING MODE [ ]/[ ] buttons Pressing these buttons repeatedly cycles through all of the listening modes that can be used with the current input source. When this mode is selected, the AV receiver's display is turned off and only the HDMI OUT outputs video signals. [ALL ST] button This button selects the All Channel Stereo listening mode. POWER ON OFF PURE AUDIO MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 PHONO TAPE TUNER CD DISPLAY PHONES ZONE 2 OFF TONE STEREO DIMMER TUNING MEMORY MODE VIDEO 4 INPUT SETUP RETURN ENTER SETUP MIC LISTENING MODE ZONE 2 LEVEL CLEAR PRESET TUNING PRESET DIGITAL S VIDEO VIDEO L AUDIO R PURE AUDIO LISTENING MODE [PURE AUDIO] button This button selects the Pure Audio listening mode. When this mode is selected, the AV receiver's display is turned off and only the HDMI OUT outputs video signals. LISTENING MODE [ ]/[ ] buttons Pressing these buttons repeatedly cycles through all of the listening modes that can be used with the current input source. 60 Using the Listening Modes--Continued The following table shows which listening modes can be used with each input signal format. Source format Analog, PCM*1 CD, TV, radio, cassette, etc. 3/2. 1 2/2. 1 Dolby Digital 2/0 1/0, 1+1 Other 3/2. 1 2/2. 1 DTS/DTS 96/24*2 DTS-ES 2/0 Discrete Matrix Multich analog, Multich PCM*3 DVD, DTV, etc. DVD, CD, etc. DVD Listening mode Pure Audio Direct Stereo Mono Multich PLIIx Movie/Music/Game Neo:6 Cinema Neo:6 Music *5 Dolby D Dolby Dolby D EX Dolby D+PLIIx Music Dolby D+PLIIx Movie DTS, DTS 96/24 DTS-ES Discrete DTS DTS-ES Matrix DTS+Neo:6 DTS+Dolby EX DTS+PLIIx Music DTS+PLIIx Movie THX Cinema THX*5 THX Surround EX THX Select2 Cinema THX Music mode THX Games mode Mono Movie Orchestra Unplugged Studio-Mix TV Logic All Ch Stereo Full Mono *4 *6 Onkyo Original DSP *5 *1. In the Pure Audio and Direct listening modes, 32 kHz, 44. 1 kHz, and 48 kHz PCM is processed at 64 kHz, 88. 2 kHz, and 96 kHz respectively. In listening modes other than Pure Audio, Direct, and Stereo, 96 kHz PCM is processed at 48 kHz. In listening modes other than Pure Audio, Direct, Stereo, and DTS 96/24, DTS 96/24 sources are processed as normal DTS. The Multich listening mode cannot be used with 176. 4/192 kHz PCM sources connected to an HDMI IN. If the Surr Back parameter is set to None, or the ZONE 2 SPEAKERS terminals are being used, normal Pro Logic II is used. [. . . ] In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again. Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit's malfunction. Before you record important data, make sure that the material will be recorded correctly. [. . . ]