User manual ONKYO UP-DT1 REMOTE CODE

[. . . ] Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. [. . . ] Do not leave rubber or plastic items on this unit for a long time, because they may leave marks on the case. If you do not use this unit for a long time, it may not work properly the next time you turn it on, so be sure to use it occasionally. Memory backup The UP-DT1 uses a battery-less memory backup system in order to retain radio settings when it's unplugged or in the case of a power failure. Turn off the Universal Port-compatible Onkyo product before setting the Mode selector. THROUGH: Select this to listen to the device connected to the UP-DT1's Universal Port, for example, an iPod in a UP-A1 dock. AUTO: When AUTO is selected, the source is selected automatically when the input source is changed on the Universal Port-compatible Onkyo product. For example, selecting the TUNER input source selects the UP-DT1, while selecting the Note that some Universal Port-compatible Onkyo products do not support this functionality, in which case you will need to set the Mode Selector manually. Use thumbtacks or something similar to fix the DAB antenna into position. Once the UP-DT1 is ready for use, you'll need to select a DAB station and adjust the position of the DAB antenna to achieve the best possible reception. You can control the UP-DT1 with your Universal Port-compatible Onkyo product's remote controller. Aim it at your Universal Port-compatible Onkyo product, not the UP-DT1. You can use the following buttons on your Universal Port-compatible Onkyo product's remote controller. Used to switch the listing mode: alphabetical order, multiplex order, or active stations order. Turn on the Universal Port-compatible Onkyo product which the UP-DT1 is connected. If a new DAB station is introduced, or you move to a new area, you can run the Auto Tuning function again. Once the scanning process is complete, the first station that was detected is selected. Press the [DISPLAY] button repeatedly to display more information about the current DAB station. When tuned to a station that's broadcasting DLS text data, the text will scroll across the display. Stations that cannot be received properly appear at the bottom of the list. With the DRC (Dynamic Range Control) setting, you can reduce the dynamic range of DAB digital radio so that you can still hear quiet parts even when listening at low volume levels--ideal for listening to the radio late at night when you don't want to disturb anyone. [. . . ] the displays shown in this instruction manual serve as examples only. If you can't resolve an issue yourself, try resetting the UP-DT1 as follows before contacting your Onkyo dealer. When the UP-DT1 has been recognized, while holding down the [PORT] button on the front panel of the product, press the [STANDBY/ON] button on the front panel of the product. (The reset procedure may vary depending on your Universal Port-compatible Onkyo product, so refer to its instruction manual as well. [. . . ]