User manual OREGON BAR1000A

[. . . ] Placement of this product on certain types of wood may result in damage to its finish for which Oregon Scientific will not be responsible. consult the furniture manufacturer's care instructions for information. The contents of this manual may not be reproduced without the permission of the manufacturer. [. . . ] CLOCK: Set time and display mode / : Increase / decrease setting; activate / deactivate clock reception signal AUTO ON / OFF: Select auto toggle mode °C / °F: Select temperature unit and display mode Battery compartment EU / UK: Select the nearest radio signal (BAR1000 only) RESET: Reset unit to default settings BAR1000: Time zone offset sets the clock +/- 23 hours from the received clock signal time. If you have deactivated the clock signal reception, do not set a value for time zone offset. To manually toggle between time, outdoor temperature and indoor temperature, press CLOCK or wave your hand at least 1. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. NOTE The installed CDS light sensor inside the unit will activate automatic LCD dimming. To completely disconnect from power, the adaptor should be disconnected from the main unit. NOTE The main unit and adaptor should not be exposed to wet conditions. No objects filled with liquid, such as vases, should be placed on the main unit and adaptor. [. . . ] 2) This device must accept any interference received, including interference that may cause undesired operation. Place the outside sensor within 30 m (98 ft) of the main unit using the table stand or wall mount. You may need to experiment with various locations 5 tum) 350 g utan batteri -5°C till 50°C (23°F till 122°F) -30°C till 50°C (-22°F till 122°F) 433 MHz 4 x UM-3 (AA) 1. [. . . ]