User manual OREGON BAR332ESA

[. . . ] 6 Remote Sensor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Clock and Calendar . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Clock Reception . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Manually Set Clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Calendar / Clock with weekday / seconds TOP viEW 1 2 3 4 5 6 . 3. SEARCh: Initiate sensor search RESET: Reset unit to default settings °C / °F: Select temperature unit 3 EN EN SOlAR PANEl REMOTE SENSOR 4 1 5 123 . CHARGING: charging in process FULL: batteries fully charged (when TEST is pressed) Solar panel TEST establish if battery is full Battery compartment . LED status indicator Wall mount hole Battery compartment 2 3 4 5 RESET: Reset unit to default settings ChANNEl switch GETTiNG STARTED SOlAR PANEl This product uses two AAA rechargeable batteries which should be charged via the solar panel. For the batteries' first charge, it is strongly advised to charge it for at least 2 hours. 4 To charge the battery: . Detach solar panel by exerting downward pressure and pulling at a 45° angle (approx. ) away from main unit. TiP Press and hold TEST located at the back of the solar panel. Push solar panel towards main unit and snap into place. 5-6 hours of battery charging will normally provide power to operate unit for 2 months. When the rechargeable battery is nearly flat or when solar panel has been detached, the (green) LED indicator on the main unit and will flash. TiPS · · 2. Insert 2 AAA rechargeable batteries in battery compartment located at the back of the solar panel. For best results when charging the battery, place the solar panel directly with view to sunlight. Direct solar panel as follows: Solar panel facing: North South Place ONLY NiMH type rechargeable batteries in the solar panel battery compartment. Expose the solar panel directly to sunlight for approximately 5-6 hours to charge the battery. The (red) CHARGING LED on solar panel will light up indicating there is sunlight and unit is charging. if you reside in the: Southern Hemisphere Northern Hemisphere iMPORTANT · · · Do not scratch the solar panel's surface or wipe it with strong detergent. The duration of the rechargeable battery's charging or operating time is determined by either the intensity of sunlight or the position of the solar panel towards the sun. Do not overcharge the batteries. · 5 EN EN BACkUP POWER 1 piece AAA battery In the case when the rechargeable battery is flat or nearly flat or when the solar panel has been detached, the AAA battery can act as backup power supply for the main unit. Press and hold SEARCh for 2 seconds to initiate a sensor search. NOTE Use alkaline batteries for longer usage and consumer grade lithium batteries in temperatures below freezing. The remote sensor reception icon will show the following status: iCONS MEANiNG Main unit is searching for sensor(s) A sensor channel has been found No sensor found Power adaptor (not included) The adaptor powers the unit and can also be used for charging the rechargeable battery. When connected to the main unit, will be displayed. NOTE The main unit and adaptor should not be exposed to wet conditions. No objects filled with liquid, such as vases, should be placed on the main unit and adaptor. REMOTE SENSOR This product can work with up to 3 sensors at any one time to capture temperature readings in various locations. Slide open the battery compartment. TiP Ideal placements for the sensor would be in any location on the exterior of the home at a height of not more than 1. 5 m (5 ft) and which can shield it from direct sunlight or wet conditions for an accurate reading. 6 BAR332ESU: UK: MSF-60 signal: within 1500 km (932 miles) of Anthorn, England. [. . . ] Placement of this product on certain types of wood may result in damage to its finish for which Oregon Scientific will not be responsible. Consult the furniture manufacturer's care instructions for information. The contents of this manual may not be reproduced without the permission of the manufacturer. Collection of such waste separately for special treatment is necessary. [. . . ]