User manual OREGON JM889NU

[. . . ] 4 Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Placement of unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Indoor temperature display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Radio reception . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] button Used to adjust settings down one notch or to enable/disable RF radio reception button Used to adjust settings up one notch or to enable/disable RF radio reception Icon Description Explanation Radio Reception Indicates the condition of radio reception. Signal Low Battery Appears when power is low. Alarm-on Alarm Time Indicator Appears when alarm is activated. 3 GB GB SAFETY AND CARE INSTRUCTIONS Safety Precautions Please observe the following safety precautions when setting up and using this product. · LCD panel - The LCD panel is made of glass, and may break if the unit is dropped or impacted. · Heat sources - Keep the product away from heat sources such as radiators, stoves, heaters, and other heat-generating products. · Water and moisture - Do not use the product in or near water or in high moisture areas such as a bathroom. Caring for your Product To ensure you receive the maximum benefit from using this product, please observe the following guidelines. · Ventilation - The vents and other openings are designed for ventilation, and should not be blocked or covered. Blocking the vents can cause the product to overheat, and can damage the unit. · Repair - Do not attempt to repair the product or modify the circuitry by yourself. Contact the retailer or a qualified repairman if the product requires servicing. 4 · Do not scratch hard objects against the LCD display as this may cause damage. GETTING STARTED Unpacking the product When you unpack your clock, make sure to keep all the packing materials in a safe place, in case you need to later transport or return it for servicing. In the box, you will find: Clock unit Batteries User manual Batteries NOTE When using the product for the first time, please note that the batteries have already been installed in the unit. To operate, locate the clear plastic battery tab inside the battery compartment and remove it. Locate the battery compartment. Placement of Unit You can either mount the main unit on a wall or make it stand on a flat surface. Method Table Stand Instruction Diagram The unit is already equipped with a Table Stand. Simply pull out the Table Stand and rest the main unit on a flat surface. 2. Warning: Reversing the polarity may damage the product. Wall Mount The main unit can be mounted onto a wall using a No. a) Position and nail the screw into the place where you would like to hang your main unit. b) Leave ample space between the wall and the screw head while testing to make sure the nail is secure. c) Fit the unit's Wall-Mount Recess Hole onto the screw head. NOTE Replace the batteries whenever the weak battery mark ( ) is shown, the display is dim, or the display does not illuminate when the power is on. Replace all the batteries at the same time - it is dangerous to mix old and new batteries. [. . . ] Problem Symptom Radio antenna not The RF signal displayed on LCD cannot be screen. Check This Obstacles (either electromagnetic interference or objects) are barring the signal from reaching the main unit. Orientation or placement of main unit is not optimum for receiving the RF signal. Remedy Move the unit away from any sources of interference, including other electronic devices. [. . . ]