User manual OREGON RM368PU

[. . . ] If the signal is weak, it can take up to 24 hours to get a valid signal. The settings order is: time zone, 12/24 hr format, hour, minute, year, calendar mode (month ­ day / day ­ month), month, day and language. Time zone offset sets the clock +/- 23 hours from the received clock signal time. [. . . ] NOTE The technical specifications for this product and the contents of the user manual are subject to change without notice. nOTE Features and accessories will not be available in all countries. If you're in the US and would like to contact our Customer Care department directly, please visit: www2. Hereby, Oregon Scientific, declares that this Slim Projection Clock (Models: RM368P / RM368PU / RM368PA / RA368P) is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the signed and dated Declaration of Conformity is available on request via our Oregon Scientific Customer Service. Press any other key to turn the alarm off and activate it again after 24 hours. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. NOTE If projection is illuminated, do not look directly into the projector. Make sure the adapter is not obstructed and is easily accessible to the unit. To completely disconnect from power, the adapter should be disconnected from the main unit. [. . . ] This product is designed to synchronize its clock automatically with a clock signal. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. [. . . ]