User manual OREGON RRM612PU

[. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Press any other button to turn the alarm off and activate it again after 24 hours. To completely disconnect from power, the adaptor should be disconnected from the main unit. [. . . ] Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. FOCUS wheel: adjust projection focus ALARM ON/OFF slide switch: enable or disable alarm SLEEP: activate sleep timer 1, 2, 3, 4: preset radio stations RADIO ON/VOL volume RADIO OFF/VOL volume : turn on radio; increase radio : turn off radio; decrease radio The following information is not to be used as contact for support or sales. NOTE If no button is pressed after 10 seconds, the unit will When clock signal reception is enabled (RCC CLOCK ON/OFF slide switch is ON), reception will occur regularly at 01:00, 02:00 and 03:00, or 3 minutes after every reset of unit. During reception, display will be temporarily off and only a flashing will be shown. Display will resume after the reception, or upon pressing of any key, display will be temporarily on for 10 seconds. Do not subject the unit to excessive force, shock, dust, temperature or humidity. Do not cover the ventilation holes with any items such as newspapers, curtains etc. If you spill liquid over it, dry it immediately with a soft, lint-free cloth. When disposing of this product, ensure it is collected separately for special treatment. Placement of this product on certain types of wood may result in damage to its finish for which Oregon Scientific will not be responsible. consult the furniture manufacturer's care instructions for information. The contents of this manual may not be reproduced without the permission of the manufacturer. Collection of such waste separately for special treatment is necessary. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. During reception, pressing any button or turning on the radio will stop the reception temporarily. [. . . ] But, if the top cover is opened, pressing SNOOZE can turn on the projection for 5 seconds. Hereby, Oregon Scientific, declares that this Smart Projection Clock with Mirror Projector and LED Display (model: RRM612P / RRM612PU / RRM612PA) is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the signed and dated Declaration of Conformity is available on request via our Oregon Scientific Customer Service. [. . . ]