User manual OREGON SKT338N

[. . . ] ), press [START/STOP] button once to activate count-up feature and Timer starts to count up at 1 second intervals. Press [START/STOP] button 3rd time, count-up timer will continue to count up at 1 second intervals. [. . . ] Last 1 minute sound level warning Press [SET] button ( a beeping sound can be heard ) and at the same time press [SEC] button ( a beeping sound can be heard ) to reset second digits to zero when second digits are within 0-30 sec. Following the arrow direction, use a money coin to open the battery cover at back side of Timer. 5V C-13 or SR44 size button cell battery (make sure '+' is facing outward) and close battery cover. The Timer can clip on thin board or shirt pocket by using the plastic clip at back side of Timer. Press and hold [HR] button for 2 seconds will set the hour digits more quickly. Press and hold [MIN] button for 2 seconds will set the minute digits more quickly. If setting is not the desired one, press [RESET] button once to reset Timer to zero and set time again. The Timer can attach to iron or steel surfaces by using the magnet at back side of Timer. The Timer can stand on table surface by filipping out the metal stand bar at back side of Timer. After time is set, press [START/STOP] button once and Timer will start to count down at 1 second intervals. When Timer is counting, press [START/STOP] button once and timer will stop. - The contents of this manual is subject to change without further notice. - Due to printing limitations, the displays shown in this manual may differ from the actual display. - The manufacturer and its suppliers hold no responsibility to you or any other person for any damage expenses, lost profits, or any other claim as a result of using this product. [. . . ] After Timer alarm stops, press [START/STOP] button once to recall presetting desired count-down time. Press [START/STOP] button 2nd time to start Timer and Timer will count down for another lap. [. . . ]